707630
17
Zoom out
Zoom in
Previous page
1/44
Next page
17
Fig. 1 Paneling for water connections
Fig. 2 Unscrew the back panel
Fig. 3 Sensor pocket Sensor pocket for
for TAS temperature sensor
„Temperature Difference
Controller“
Installing the stove
The oor on which the stove is installed must be even
and horizontal. The stove may only be installed on an
adequate loadbearing oor. The stove can be stood on
a metal oor sheet or glass sheet to protect the oor-
ing.
If the ooring or carpet is inammable, a stable and
non-combustible spark protection plate must be used.
This must extend 50 cm to the front and 30 cm to each
side beyond the edge of the combustion chamber
opening. Under the stove no spark protection plate is
required.
Assembly sequence
Since by the installation of the side cladding and the
OEC (manuals are included with the respective pack-
aging units) and by the connection change of the con-
nection support, the cover hood is removed, the reas-
sembly of the cover hood should only occur if all add-
on parts are attached.
Remove the top cover.
Unscrew the paneling for water connections of the
back panel (Fig. 1).
Unscrew the back panel (Fig. 2).
Slide the temperature sensor of the “Temperature
Difference Controller” into the right-hand sen-
sor pocket and secure it using the threaded screw
(Fig. 3).
The connection of the ue Ø 150 mm may optional-
ly occur from above or from the back. The device is
delivered for connection installed from above.
If there should be a rear connection, it must be in-
stalled in the following steps:
- Break out the cover in the back panel.
- Replace the connector sleeve and the sealing
cover.
Screw the pack panel.
If required, assemble OEC.
Install side cladding.
Place the top cover back.
Flue connection from the back: Close off the hole in
the top cover with the en-closed insertable cap.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olsberg Tolima Aqua II Compact at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olsberg Tolima Aqua II Compact in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info