812264

Olsberg ARINA 2.0 Manual

83
Zoom out
Zoom in
Previous page
1/160
Next page
Operating manual
for the user
LEVANA 2.0 6 kW
LEVANA 2.0 8 kW
LEVANA AQUA 2.0
ARINA 2.0
INARA 2.0
EN
Attention: the switching times must always relate to one day, i.e.
a switching time may not exceed the 24 hour limit. Switching on
before midnight and switching o after midnight cannot be recog-
nised by the software. If a switching time of more than 24 hours
should be dened, then a switch-o time of 23:59 must be entered
for the rst day, with a switch-on time of 0:00 for the following day.
3 dierent switching pairs can be dened for each block of days or
week day. If a target temperature is desired, select the eld after the
time pair (for “Automatic” operating mode only) and then save.
Temperature range which can be set: 10 °C – 40 °C
or no temperature (---)
Factory setting: ---
“DATE/TIME” display
Time zone offset
Summer time offset is done automatically
next
.07.2021
1h
17:10
20
Fig. 3.27 Touch control panel – Setting the date and time
The change can be made by selecting the appropriate number eld.
“CHILD LOCK” display
The “Child lock” can be activated in order to prevent unintentional changes
on the touch display. A lock appears as a symbol in the top right of the
display. The child lock is activated by pressing the time for 3 seconds. The
function is deactivated by repeatedly pressing the button.
Ready
15:32
AUTO mode
Desired °C
Actual °C
17
25
Party
Fig. 3.28 Touch control panel – Child lock
“INFORMATION” display
07:12
SW Version
Service
op.hours
Ext. request
2.02.17L6
2000h
0h
off
Fig. 3.29 Touch control panel – Displaying information
You can nd the following information in this display:
ū The current software version (e.g. 2.02.17 L6)
ū Time to next service. The pellet replace must be serviced at regu-
lar intervals. A service is automatically requested after 2000 operating
hours. Call a service technician to carry out the service. The “Carry out
service” notication continues to appear until the service technician
carries out the service and resets the notication in the service menu.
ū Operating hours counter
ū External requirements
ū An external room thermostat can be connected as an “external re-
quirement”. Since the internal room temperature sensor is also
still connected, the signal which switches first is used for regula-
tion. If the target temperature should be specified via the external
room thermostat, then the room temperature which can be set in
“Automatic” mode must be set to the maximum value (40 °C).
ū This display can be used to check whether the external room ther-
mostat has been connected correctly and is assuming regulation
of the pellet replace. “On” or “O” must be shown on the display
when adjusting the room temperature to higher or lower than
the current room temperature on the room thermostat.
ū If no external components are connected, the “On” is always
displayed.
Operating keys in the “Information” display
SYSTEM INFO
Shows the most recent error messages
CURRENT INFORMATION
Display:
- Flame temperature
- Output stage
- Induced draft fan speed
- Vacuum
SERVICE MENU
Password protected area for service technicians
(Note: the specialist dealer can obtain the password for the
service menu from Olsberg customer service).
We reserve the right to make technical changes
83
78-4643-2481_R6_LEVANA 2.0_ARINA 2.0_INARA 2.0_DE-EN-FR.indd 8378-4643-2481_R6_LEVANA 2.0_ARINA 2.0_INARA 2.0_DE-EN-FR.indd 83 11.04.2023 14:41:5911.04.2023 14:41:59
… 83 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olsberg ARINA 2.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olsberg ARINA 2.0 in the language / languages: English, German, French as an attachment in your email.

The manual is 34.97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info