563101
63
Zoom out
Zoom in
Previous page
1/81
Next page
Troubleshooting > 63
Print position offset
The horizontal printing
position is offset.
The start position may
change after the printer is
powered on.
When the printer is powered
ON, switch from off-line mode
to on-line mode by pressing
the SEL button. Reset the
start position. You must set
the Power Switch to OFF
before you change the start
position.
Printing slows down
Print direction changes
suddenly to unidirectional.
When the print head
overheats, the printer
automatically starts
unidirectional split printing.
When the print head
temperature drops
sufficiently, the printer will
return to its original
operation.
PE warning
The print carriage does not
operate.
There is contamination on the
carriage shaft.
Clean any paper dust and
contamination from the
carriage with a dry cloth.
Print blurring
The characters are too pale to
display properly on the paper.
The Paper Thickness lever
position does not match the
paper.
Correct the Paper Thickness
lever setting.
The printer is set to print at
high speed.
Set the speed to normal.
The ribbon has reached its
end of life.
Replace the ribbon by a new
one.
The ribbon cartridge is not
installed correctly.
Reinstall the ribbon cartridge
correctly.
The ribbon has been wound
incorrectly.
Replace the ribbon cartridge
by a new one.
The ribbon is not transferring
properly.
Replace the ribbon cartridge
by a new one.
A line of print is missing. Broken wire pins. Contact your dealer.
The printout differs from the screen display.
Printout of completely
different characters or
symbols.
Incorrect print setup for the
user application.
Reselect print setup for the
applications according to
priority.
The application control codes
for the previous print
operation are still enabled.
Initialise the printer.
The input application control
signal is not correct.
Print in hex dump mode and
verify the data content. Make
corrections in the application.
The interface cable is not
properly connected.
Reconnect the cable correctly.
PROBLEM CAUSE ACTION
63


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oki ML5721 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oki ML5721 in the language / languages: English as an attachment in your email.

The manual is 5,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info