772999
8
Zoom out
Zoom in
Previous page
1/61
Next page
10 11
ENGLISH
ENGLISH
Sirius rear child‘s seatSirius rear child‘s seat
vertical position of the child seat; when the height is right; tighten
the screws rmly in place.
Illustration 7:
Take the seat and insert the two ends of the support arm (5) into the
fastening block holes. Place the backrest upright using the knob (16)
(see ill. 2) rotating it in an anti-clockwise direction. Now check that:
- the barycentre reference point (19) on the seat is not over 10cm
from the centre of the wheel.
- the child seat is at least 6-7 cm from the mudguard, from the
wheel or from any luggage racks.
- If the child seat barycentre reference is not between the set
parameters, adjust the horizontal position as follows:
Illustration 8:
When the backrest is in an upright position, loosen the screws (20)
using the supplied wrench.
WARNING! Do not unscrew the screw (20) completely, just loosen
it enough to slide the seat on the plate. Slide the seat forwards or
backwards until you reach the recommended barycentre position.
Tighten the screws (20). Your child seat is now correctly tted onto
your bicycle. Adjust the vertical position following the instructions in
the diagram; when the seat is correctly in place, tighten the screws
(9) slowly and evenly until the fastening block stops rotating around
the frame. Slide the cover (18) over the front part of the fastening
block (8). Cover the counter-block (7) with the protection cover (11).
Illustration 9:
Fastening the footrest. To fasten the footrest insert it in the high-
est position on the shaped adjuster slot, while keeping the x-
ing bridges of the safety belt on the outside of the seat. Insert the
regulating pin (21) from the outside of the seat towards the inside
as illustrated, making sure that the right pin meets the right side
and vice versa. Both the pins and sides of the seat are marked with
DX=right and SX=left. Slide the footrest (4) down.
Illustration 10:
Extracting the footrest. To extract the footrest, turn the adjuster
lever (21) upwards, move the footrest (4) upwards as far as possible,
remove the adjuster lever outwards to free the support.
Use of the seat:
Illustration 11:
Setting the inclination of the child seat. Press and turn the inclina-
tion knob (16) until the backrest is in the desired position.
WARNING! When adjusting the inclination of the backrest, the child
seat moves forward and the footrests may catch when pedalling.
Illustration 12:
Adjusting the footrest: To adjust the height of the footrest (4), turn
the adjuster lever (21) upwards, once you have found the right posi-
tion, turn the adjuster lever downwards to x the footrest in place
Illustration 13:
Fastening and unfastening the child’s feet. Make sure your child’s
feet are well fastened to the footrests. The safety belt is long for
easy adjustment. To release the belt 22, lift it out to free it from the
bridge trapping it.
Illustration 14:
Fasten the child’s safety belt: Adjust the height and length of the
belts according to the size of the child. Setting belt height: the belt
can be extracted to adjust its height by inserting the buckle behind
the backrest through the opening each time (g.14). Choose the up-
per or lower openings to x the belts based on the child’s height. Set
belt length: modify belt length by sliding the buckles. The belts must
be fastened rmly without them being too tight for the child. Fasten
the belts: fasten the belt clasp. Check that the belt clasp clicks shut
properly, and then pull the belt.
Illustration 15:
Unfastening the belts. Press simultaneously the two side and cen-
tral press-buttons on the clasp. The clasp will open.
Illustration 16:
Removing the child seat: Press the release button (1) on the fasten-
ing block (8) and remove the child seat. To hook the seat on again,
insert the support arm (5) in the two xing block holes (8) until the
lever clicks.
Maintenance
1) Clean the seat, the padding and the belts with warm water and a
mild detergent. Do not use solvents or abrasive or corrosive de-
tergents. Leave the padding to dry in the open air. Do not iron.
2) Seat repairs and replacement of damaged components must only
be carried out by authorized personnel.
Technical specications
Product Child bicycle seat OKBABY mod. Sirius
Dimensions 41x45x70 CM (LxDxH)
Weight 5.3Kg
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Okbaby Sirius at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Okbaby Sirius in the language / languages: All languages as an attachment in your email.

The manual is 5.26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Okbaby Sirius

Okbaby Sirius User Manual - English - 7 pages

Okbaby Sirius User Manual - Dutch - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info