772999
7
Zoom out
Zoom in
Previous page
1/61
Next page
8 9
ENGLISH
ENGLISH
Sirius rear child‘s seatSirius rear child‘s seat
al. Do not tighten the screws excessively and check the tightness
periodically.
2) Check that the bicycle is suitable for adding supplementary
loads. Check the information supplied with the bicycle or ask for
information and advice from the bicycle manufacturer.
3) Adjust the seat and its components in order to give the child
the most comfort and safety. When the child is in the seat, the
backrest should be slightly tilted backwards, so as to prevent the
child from sliding forward.
4) Check to ensure that each part of your bicycle is working prop-
erly with the seat mounted.
5) Check the existence of any laws present in your State that govern
the use of bicycle seats to carry children.
6) Check initially and then periodically that the weight and size of
the child does not exceed the maximum allowed by the seat.
7 Check that the child or part of its clothes do not come into con-
tact with moving parts of the seat or bicycle. Avoid the child’s
hands and feet coming into contact with the wheel or being
caught in the brakes.
8) Ensure that there are no sharp edges that could come into
contact with the child (for example, frayed or deteriorated wires
etc.).
9) Ensure that the safety belts are not loose and do not come into
contact with the moving parts of the bicycle, especially with the
wheels, even when the child is not being carried in the seat.
10) Always use the safety belts. Make sure your child is properly
secured with the seat belts.
11) The child in the seat must be clothed and protected from the
cold more than the person riding the bicycle. Protect the child
from rain.
12) It is advised to make the child wear an approved protective hel-
met.
13) Check that the seat is not too hot (e.g., overheated by the sun)
prior to placing the child in it.
14) Remove the seat when the bicycle is transported by car. Strong
wind could damage the seat or detach it from the bicycle, caus-
ing accidents.
15 Cover any saddle springs to avoid a child’s ngers being trapped
and/or squashed by them.
16) Each time the seat is used, check it is tted onto the fastening
block correctly: on pulling the support arm upwards, the fasten-
ing block must hold the seat down rmly.
17) The seat material (polypropylene) loses some of its mechanical
properties with ageing if exposed for longer periods to environ-
mental conditions (sun, rain, ice, etc.). In the case of normal use
and exposure to environmental conditions, the seat should be
replaced after 3 years.
Warnings
1) WARNING: Do not place any additional baggage on the seat. Any
additional baggage must be placed on the opposite side of the
bicycle with respect to the seat. For example: if the seat is in the
rear of the bicycle, use a front bag carrier and vice versa
2) WARNING: Do not modify the seat.
3) WARNING: Riding the bicycle may be dierent with a child in the
seat, especially regarding balance, steering and braking.
4) WARNING: Never park the bicycle leaving the child unattended in
the seat.
5) WARNING: Do not use the seat if any part is missing or broken.
Mounting and assembling the child seat
Illustration 1:
fasten the backrest to the metal support.
Phase 1 : Open the fastening cover (14)
Phase 2 : Raise the backrest until it rests on the metal support
Phase 3 : Close the fastening cover (14) and push it upwards to hook
on the safety lever (24).
Illustration 2:
Incline the backrest as far as possible by pressing the knob down-
wards whilst rotating it (16) clockwise.
Illustration 3:
Insert the support arm (5) pushing it into the correct position (25).
Illustration 4:
Insert the fastening plate (12) pushing it as far as possible and then
hook it on using the safety tab (26) over wall (27) as seen in the
diagram.
Illustration 5:
Screw on the xing bridge (13)
Illustration 6:
Check the diameter of the frame and choose the most suitable
plastic adaptor (10). The reference diameter is indicated on each
adaptor. Fix the fastener block (8) and the fastener counter-block (7)
in place, placing the plastic adaptor (10) and the soft plastic reducer
(17) in between them. The plastic adaptor (10) has specic grooves
to hold the cable glands welded to the frame and the cables. Do
not tighten the fastener screws (9) completely so you can adjust the
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Okbaby Sirius at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Okbaby Sirius in the language / languages: All languages as an attachment in your email.

The manual is 5.26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Okbaby Sirius

Okbaby Sirius User Manual - English - 7 pages

Okbaby Sirius User Manual - Dutch - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info