Instructions for use and assembly LIB006R05 Edition: 05-2005
Chapter 6 Child’s bicycle seat OKBABY SIRIUS Page 70 Chapter 7 Child’s bicycle seat OKBABY SIRIUS Page 71
Instructions for use and assembly LIB006R05 Edition: 05-2005
plate. Slide the seat back and forwards
until you reach the ideal centre of gravity.
Tighten the screw 19.
Your seat is now correctly fastened to
your bike.
Illustration 9:
Try several times to tilt the seat back as
far as possible, turning the knob (16)
clockwise and anti-clockwise. Raise the
seat if it is too close to the wheel, and
lower it if it is too far away. In this case,
proceed as follows. Illustration 6:
If necessary, loosen the four lockscrews
(9) on the fixing counter-block (7). Slide
the whole frame fastening block up and
down until you reach the desired position.
Tighten the screws (9) slowly and evenly
until the fixing block stops rotating around
the frame. Do not tighten the screws too
much.
Illustration 10:
Fixing the footrests.
To fix the footrest, insert it into the highest
position in the shaped adjustment
housing, keeping the fixing bridges of the
belts outside the child’s seat. Insert the
regulating pin 21 from the outside of the
seat towards the inside, as shown,
making sure that the right pin meets the
right side and vice versa. Both of the pins
and sides of the seat are marked with
DX=right and SX=left. Slide the footrest
(4) downwards.
Illustration 11:
Extracting the footrests.
To extract the footrest support, rotate the
adjustment lever 21 upwards, slide the
footrest (4) into the highest position,
extract the adjustment lever externally to
release the support.
7 Use
Illustration 1:
Adjusting the inclination of the child’s
seat.
Rotate the inclination knob (16) until the
desired position of the backrest.
DANGER! Changing the inclination
of the backrest, the seat moves for-
ward and the footrests could interfere with
pedalling.
Illustration 2:
Adjusting the footrests.
To adjust the height of the footrest (4)
rotate the adjustment lever 21 upwards,
and when the position desired is reached,
rotate the lever downwards to fix the
footrest support in the desired position.
Illustration 3:
Blocking and releasing the child’s feet.
Always make sure that your child’s feet
are well fastened to the footrests. The
strap is long for easy adjustment.
To unhook the strap 22, lift it outwards
and free it from the bridge trapping it.
WARNING! Do not tighten the belt
on the child’s foot too tightly, you could
hurt him/her or he/she could get cramp
during the ride.
ENGLISH
ENGLISH
4
DX
DX
21
421
90° 120°
21 4
22
