783024

OK ODW 132 F Manual

19
Zoom out
Zoom in
Previous page
1/79
Next page
19
EN
INSTALLATION
Note: The dishwasher is equipped with power cord and plug. Make sure before installation, that a
suitable mains outlet is at the desired place of installation.
Consider the dimension of the product for placing and installation.
1 Place the dishwasher on an even, horizontal and steady surface, e.g. place it on a suitable desk in
your kitchen.
Note: The dishwasher is not intended to be built in.
2 The dishwasher must be connected to drainage.
1. The hose is already connected the waste water outlet, at the back of the product. Cut the straps
and unwind the hose.
2. Connect the end to a drainpipe. Observe the max. height of the outlet of drainage hose.
Note:
A suitable hose holder is available as optional accessories.
3 Connect the water inlet to a tap water supply (3/4”) using the provided hose and make sure it is
correctly sealed and fasten tightly.
Note: If the water pipes are new or have not been used for an extended period of time, let
the water run for some time, to make sure that the water is clear and free of impurities. If this
precaution is not taken, there is a risk that the water inlet can get blocked and the appliance might
be damaged.
4 Connect the power plug to the mains.
Note: Before using the product for the rst time, make sure that all hydrophilic connections of the
product are correctly sealed and connected to both the device as well as the water mains. Check all
connections periodically to avoid possible leakage.
PREPARATION
5 Filling salt into the salt container
Depending on your tap water hardness (hardness degree) use additional salt (water softener).
Always consider the instruction provided with the salt.
1. Remove the basket and then unscrew and remove the cap from the salt container.
2. Before rst usage, pour 1 lt. of water in the salt container of your machine.
3. Place the end of the funnel (supplied) into the hole and ll in about 1 kg of salt. It is normal for a
small amount of water to come out of the salt container.
4. After lling the container, screw the cap tightly back on in a clockwise direction.
5. Immediately after lling the salt into the salt container, a washing program must be started
(rapid program suggested). Otherwise the lter system, pump or other important components
of the machine may be damaged by the salt, which voids the warranty.
Note: Usually, the salt warning light will be cease to be illuminated within 2-6 days after the salt
container has been lled with salt. Depending on how fully the salt dissolves, the salt warning light
may still be on even though the salt container is lled.
Warning!
• Only use salt specically designed for use in dishwashers! All other types of salt not specically
designed for use in a dishwashers, especially table salt, will damage the water softener. In case of
damages caused by the use of unsuitable salt the manufacturer does not give any warranty and is not
liable for any caused damages.
• If salt has been spilled, a soak or a rapid program must be run to remove the excess salt.
• Only ll in salt just before starting one of the complete washing programs. This will prevent any grains
of salt or salty water, which may have been spilt, remaining of the bottom of the machine for any
period of time, which may cause corrosion.
• The salt container must only be relled when the salt warning light in the control panel comes on.
IM_ODW131F_ODW132F_201117_V13_HR.indb 19IM_ODW131F_ODW132F_201117_V13_HR.indb 19 19/11/2020 10:06 AM19/11/2020 10:06 AM
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for OK ODW 132 F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of OK ODW 132 F in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 13.78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info