782907
13
Zoom out
Zoom in
Previous page
1/93
Next page
13 eN
INSTALLATION
1 Place the product on an even, horizontal and steady surface.
2 If desired, two batteries can be inserted so that in the event of a power failure, settings are
maintained. Open the battery compartment by removing the cover. Insert 2 batteries type AAA/
LR03 (not included). Pay attention to the correct polarity (+/-) according to the imprint in the
battery compartment. Close the battery compartment cover.
3 Put the end of wire aerial up to receive at best signal strength. Connect the power plug to the
mains.
CLOCK SETUP
Clock setting is only possible in Standby/ OFF mode.
1. When product is connected with mains the rst time, 0:00 will be shown on the display in standby
mode.
2. If needed turn o the radio by pushing power button for approx. 2 seconds. Press and hold CLOCK
for 2 seconds.
3. Use the VOL/TUNE volume control to set the 12H or 24H hour format and press CLOCK to conrm.
4. Now set the hours with the volume control VOL/TUNE and conrm with CLOCK.
5. Now set the minutes with the volume control VOL/TUNE and conrm with CLOCK.
6. The setting has now been completed.
OPERATION
Switching ON and OFF
4 Press power button to switch on. For switching o, press power button for at least 2 seconds.
Mode selection
5 Press the SOURCE button to select mode in order FM radio, AUX (Audio in), CD and USB (USb).
Volume control
6 The loudspeaker volume can be easily controlled by turning the volume control VOL/TUNE. The
volume is shown in display for a moment.
XBASS function
Press the XBASS button to raise the bass. Press again to stop the function.
7 Timer or short-circuit function
• This function is only available when the radio is switched o.
• Press the NAP button. The default time is 10 minutes. If necessary, use the volume control to set
the time in minutes. Conrm the set time and activate the timer by pressing the NAP button
again. When the set time has elapsed, an alarm sound turns on. Press the NAP or power button
to stop the alarm.
IM_OCR100_170907_V03_HR.indb 13 7/9/17 3:04 pm
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for OK OCR 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of OK OCR 100 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish as an attachment in your email.

The manual is 7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info