554357
135
Zoom out
Zoom in
Previous page
1/152
Next page
135
Transmitter Battery Installation
• Lightly lubricate the new Battery Cap O-ring with silicone
grease and install it onto the Battery Cap. DO NOT roll the
O-ring over the Threads, instead stretch it slightly to work it
down over the slotted end of the Cap into the Groove at the
Base of the Threads (Fig. 124).
NOTE: The O-ring must be a genuine Oceanic
part that can be purchased from an Authorized
Oceanic Dealer. Use of any other O-ring will
void the warranty.
• Place a new 3 volt, CR2, Lithium Battery (Duracell model DL-
CR2 or equivalent) positive (+) side down into the Battery
Compartment with the negative end facing up/out (Fig. 125).
• Ensure that the Battery is properly oriented and the Hatch O-
ring is evenly seated around the Battery Hatch.
• Carefully place the Battery Hatch with Spring into the Hous-
ing and turn clockwise slowly by hand to ensure proper
threading. Apply a coin and tighten until secure. The outer
surface of the Battery Hatch should be flush with the outer
surface of the Housing (Fig. 126).
Fig. 125 - Transmitter Battery
Orientation
Battery
(+) ( - )
Fig. 124 - Transmitter O-ring
Installation
Fig. 126 - Transmitter Battery
Hatch Installed
135


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oceanic Atom 1.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oceanic Atom 1.0 in the language / languages: English as an attachment in your email.

The manual is 2,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info