685860
14
Zoom out
Zoom in
Previous page
1/160
Next page
14 ProMax Pressure Automatic 6000/8, Pressure Well Automatic 6000/8
Horizontal installation of the pump
with the stand
(Only ProMax Pressure Automatic
6000/8)
The pump can be horizontally installed
with the stand in a shallow tank or well.
The pump has to be aligned exactly hor-
izontally.
Ensure that the water to be pumped
does not contain any sand.
How to proceed:
E
1. Remove the Allen screws.
The stand consists of two sections.
2. Push two mounting feet onto each stand
section.
3. Push three rubber pads each into the
grooves of the opening of the stand sec-
tions.
Fit rubber pads to both stand sec-
tions.
4. Push both stand sections onto the
pump.
The stand sections should be spaced
as far apart as possible to ensure the
stability of the pump.
OPERATION
The pump control system (flow control)
measures the flow and switches the pump
off if the water flow stops.
The pump switches off when there is in-
sufficient water, protecting it from being
damaged by running dry.
In automatic mode, the pump control
system switches the pump on and off.
The integrated non-return valve prevents
water from flowing back into the pump
from the pressure hose when it is switched
off. The non-return valve also prevents
damage to the pump resulting from water
hammer.
Automatic mode
The pump switches off automatically
when no more water is used and the max-
imum pressure in the pressure line is
reached.
The pump switches on automatically
when water is used and the pressure in
the pressure line falls below 3.5 bar.
WARNING
Dangerous electrical voltage!
Death or severe injury from electrocu-
tion.
Only connect the pump to the power
supply when there are no persons in or
reaching into the water.
Before stepping into or reaching into the
water, switch off all units located in the
water.
Switching on the unit
Insert the power plug into the socket.
The pump is ready for operation.
Switching off the unit
Disconnect the power plug.
When the pump is switched off, resid-
ual water in the hose may flow back
and out of the pump intake.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oase ProMax Pressure Well 6000-8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oase ProMax Pressure Well 6000-8 in the language / languages: All languages as an attachment in your email.

The manual is 3,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info