663191
10
Zoom out
Zoom in
Previous page
1/15
Next page
EN
EN
Install the NuVinci N360 CVP
into a vice or fixture as shown,
clamping on the left hand axle
flats.
If a vice is not available,
installation in the bicycle frame
is possible, tightening only the
left hand side no-turn washer
and axle nut to allow rotation
of the hub interface.
While driving the CVP clock-
wise with the sprocket (1), rotate
the entire hub interface (2) counter-
clockwise until a firm stop is felt.
Repeat this process 2-3 times by
driving the CVP clockwise and
rotating the hub interface back
and forth, ending at full
counter-clockwise.
The indicated position of the
hub interface is unimportant
in this step.
When in full overdrive, the
hub/wheel should rotate
approximately 1.8-2 times
for every 1 rotation of the
CVP sprocket.
When full overdrive is found,
remove the hub interface per
Step 5.6.
Check to make sure the mark on
the shifter nut and shift driver align
per Step 5.7.
Install hub interface per Steps 2.4
through 2.10.
At all times while rotating
the wheel, sprocket, or hub
interface, be careful not to
catch or pinch fingers.
5. SERVICE INSTRUCTIONS
Remove the rear wheel per Section 3.
Remove the hub interface per Step 5.6.
Reference the Exploded Diagram
on Page 22. Remove the sprocket
snap ring (12), sprocket spacer
(13, if installed), and sprocket (14).
Remove the snap ring (15) on
the shift driver, and remove the
freewheel assembly (16).
If servicing or replacing,
use a medium-weight oil or
lightweight water-resistant
grease and check function.
Remove the interior snap ring
(17), needle bearing (18), and RH
shield (19) if these components are
being replaced.
Install the serviced / new free-
wheel components according to
the Exploded Diagram on Page 22.
Install sprocket and hub interface
per Section 2.
Install the rear wheel per Section 3.
Servicing or Replacing
Freewheel
Set the NuVinci N360 CVP
in full overdrive with the front
shifter or hub interface prior to
removal.
17
18
19
16
15
5. SERVICE INSTRUCTIONS
17
18
5.9
5.9
5.10
5.10
5.11
5.12
5.11
5.12
1
2
(Service Part No: N360H-FREE-01)
Reference Exploded Diagram P.21
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NuVinci N360 -2010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NuVinci N360 -2010 in the language / languages: English as an attachment in your email.

The manual is 7,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NuVinci N360 -2010

NuVinci N360 -2010 User Manual - German - 15 pages

NuVinci N360 -2010 User Manual - Dutch - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info