663188
8
Zoom out
Zoom in
Previous page
1/54
Next page
Owner’s Manual - December 2008 © 2008 Fallbrook Technologies Inc.
9
English
g. Pull the wheel back in the dropout,
tightening the chain to the desired level.
Pull back on the shift rod
retaining nut, not the shift rod.
h. Keeping the wheel centered, tighten the acorn
nut with a 15mm socket and torque wrench to
40Nm (29 ft. lbs.).
Over-tightening may damage parts.
Under-tightening will result in the axle
sliding in the dropouts.
i. Still holding the wheel tight, tighten the main
shaft nut with a 21mm crows foot and torque
wrench to 50Nm (37 ft. lbs.).
Reinstalling the rear pulley housing
NOTE: If the control cables have
been pre-installed on the Cruise-
Controller and rear pulley housing
assembly, follow steps a, b and c.
If not, turn to the CruiseController
Installation section of this manual.
a. Rotate the shift rod clockwise with
your fingers until it stops; this is full
overdrive.
Be careful not to bend or
damage the end of the shift rod.
Only use your fingers.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NuVinci N170S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NuVinci N170S in the language / languages: English, German, Dutch, Danish, Spanish as an attachment in your email.

The manual is 5,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NuVinci N170S

NuVinci N170S Additional guide - German - 21 pages

NuVinci N170S Additional guide - Dutch - 21 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info