663188
7
Zoom out
Zoom in
Previous page
1/54
Next page
Owner’s Manual - December 2008 © 2008 Fallbrook Technologies Inc.
8
English
Refitting the Rear Wheel
a. Put the chain on the freewheel; orient
the axle flats so the axle can enter the
dropouts; and place the wheel in the
dropouts.
b. Install the no-turn washers on each axle
end. Orientation of the no-turn washer tabs
is determined by chain length. Place the
tabs behind the axle only if there is not
sufficient room in front.
Improper installation of the
no-turn washer will result in damage
to the dropout and the hub.
c. Grease the o-ring and the adjacent
shoulder on the shift rod and thread the
shift rod into the drive side axle by rotating
it clockwise until it stops and the shift rod
shoulder is flush with the axle.
Only use your fingers to install,
and be careful not to bend or
damage the end of the shift rod.
d. Keeping the main shaft nut tight against
the shift rod retainer nut, screw the
shift rod retainer nut onto the drive side
axle and tighten with an 11mm socket
and torque wrench to 20Nm (15 ft. lbs.)
e. Screw the acorn nut onto the non drive
side axle, but do not tighten.
f. If applicable, attach the roller brake arm
to the bike frame clamp. Do not fully tighten
the bolt until the wheel is secured in the
frame; then tighten the bolt to the torque
specified by the brake manufacturer.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NuVinci N170S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NuVinci N170S in the language / languages: English, German, Dutch, Danish, Spanish as an attachment in your email.

The manual is 5,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NuVinci N170S

NuVinci N170S Additional guide - German - 21 pages

NuVinci N170S Additional guide - Dutch - 21 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info