768528
11
Zoom out
Zoom in
Previous page
1/159
Next page
109TODL next instruction TODL next instruction
EN
EN
Product Set Up
Installation Concerns
This enhanced child restraint system is only suitable for vehicle seats
equipped with ISOFIX anchorage bars. (1)
DO NOT use the rearward facing enhanced child restraint system in seating
positions where there is an active frontal airbag installed. (2) Death or
serious injury may occur. Please reference vehicle owner’s manual for more
information.
DO NOT install this enhanced child restraint system on vehicle seats that
face sideways or rearward with respect to the moving direction of the vehicle.
Please refer to your vehicle owner’s manual for recommended or suggested
installation positions. (3)
It is recommended to install this enhanced child restraint on the rear vehicle
seat. (4)
DO NOT install this enhanced child restraint system on movable vehicle
seats.
Product Use
Base Installation
1 - Attach the ISOFIX guides to the vehicle's ISOFIX anchor bars (see vehicle
owner's manual). (5) The ISOFIX guides can protect the surface of the
vehicle seat from being torn. They can also guide the ISOFIX connectors.
2 - Unfold the load leg from storage compartment. (6)
3 - Extend the ISOFIX connectors by pressing the ISOFIX adjustment button
while pulling on the connector. (7)
4 - Press the ISOFIX adjustment button to adjust the ISOFIX connectors.
Line up the ISOFIX connectors with the ISOFIX guides, and then click
both ISOFIX connectors into the ISOFIX anchor bars. (8)
Make sure that both ISOFIX connectors are securely attached to the
vehicle's ISOFIX anchor bars. There should be two audible clicks and the
colors of the indicators on both ISOFIX connectors should be completely
green. (8)-1
Check to make sure the base is securely installed by pulling on both
ISOFIX connectors.
5 - After placing the base on the vehicle seat, extend the load leg to floor (9).
When the load leg is installed correctly, the load leg indicator will show
green. Red will be shown when installed incorrectly. (9)-2
The load leg has multiple positions. When the load leg indicator shows
red this means the load leg is in the wrong position.
Make sure the load leg is in full contact with the vehicle floor pan.
Squeeze the load leg adjustment button, then shorten the load leg
upwards. (9)-1
The completely assembled base is shown as (10).
The ISOFIX connectors must be attached and locked onto the ISOFIX
anchor bars. (10)-1
The load leg must be installed correctly with green indicator. (10)-2
6 - To remove the base, press the secondary lock button (11)-1 first followed
by the button (11)-2 on the ISOFIX connectors before removing the base
from the vehicle seat. (11)
7 - For transporting, press ISOFIX Adjustment button and move the ISOFIX
connectors back into the storage position. (12)
Use Side Impact Protection
1 - The enhanced child restraint is delivered with removable side impact
protection pod. This side impact protection pod MUST be used on the
door side of the vehicle. Installation shown in (13).
2 - Press the release button to remove side impact protection pod. (14)
Height Adjustment
for Head Support and Shoulder Harnesses
Please adjust the head support and check if the shoulder harnesses are at the
correct height according to (15)(16)(17)(18).
When used in rearward facing mode, the shoulder harness height must
be even with or just below the top of child’s shoulders. (15)
When used in forward facing mode, the shoulder harness height must be
even with the top of child’s shoulders. (16)
Pull the head support adjustment lever (17), meanwhile pull up or down the
head support until it snaps into one of the 6 positions. The head support
positions are shown as (18).
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nuna TodlNext at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nuna TodlNext in the language / languages: All languages as an attachment in your email.

The manual is 10,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info