787650
27
Zoom out
Zoom in
Previous page
1/31
Next page
USER MANUAL
ENGLISH
24
TANK AND DEBRIS COLLECTION BOX CLEANING, AND
COVER GASKET CHECK
1. Drive the machine on a level floor.
2. Ensure the machine is off and the ignition key (40) has been
removed.
3. Turn the recovery tank lid (A, Figure 25) 90 degree position
where it can be took off from the tank, and then take down the
Debris collection box (D, E Figure 25) from the tank.
4. Clean the recovery tank lid (A), recovery tank (B), clean water
tank (C), Debris collection box (D, E Figure 25),Empty the
recovery tank with the drain hose (G, Figure 25).
5. Inspect the integrity of the tank sealing strip.
NOTE
Tank sealing strip (G) makes to produce the
vacuum inside the tank when suction motor works.
The tank must be sealed can effectively absorb the
water from the ground to recovery tank.
6. Check whether the contact surface of sealing strip (G) is
integrity and sealing is sufficient. If necessary, take the sealing
strip of the tank out of the groove (H) and replace it. Assembly
the new sealing strip as shown in Figure 25, the joint should be
back in the middle area.
7. Close the recovery tank lid (A Figure 25).
DETERGENT TANK CLEANING
(For machines with Chemical Mixing System)
Clean the detergent tank (E, Figure 26) as shown below:
1. Drive the machine on a level floor.
2. Turn the ignition key (A) to "0".
3. Open the cover (B) and check that the recovery water tank (C)
is empty; if necessary empty it with the drain hose (H, Figure
26). Close the cover (B).
4. Carefully lift the tank (C).
5. Unscrew the plug (E) and disconnect the hose (F) from the tank
(G).
6. Remove the tank.
7. Wash the tank in the appointed disposal area.
8. Install the tank (G) and connect the hose (F).
9. After draining the detergent tank, drain the Chemical Mixing
System too by running the system with clean water only.
H
B
A
C
F
E
G
D
F
C
A
D
E
B
G
H
Figure 25
Figure 26
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk SC3500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk SC3500 in the language / languages: English as an attachment in your email.

The manual is 8.24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info