609446

Nilfisk-ALTO SCRUBTEC 545B Manual

74
Zoom out
Zoom in
Previous page
1/100
Next page
ENGLISH INSTRUCTIONS FOR USE
24
SCRUBTEC 545B / 545BL / 553B / 553BL / BOOST 5 - 9097054000
02/2007
05/2015
TROUBLESHOOTING
Trouble Possible Cause Remedy
The motors do not work; no warning light turns on.
The battery connector is disconnected. Connect.
The batteries are completely discharged. Charge the batteries.
The machine does not move.
(Only for SCRUBTEC 545BL, 553BL and BOOST
5)
The machine has been turned on by using
the ignition key and by keeping the switches
pressed.
Turn the ignition key to “0”, then try to start the
machine again without pressing the switches.
The warning lights (81) ash simultaneously. The brush deck motor is overloaded.
Use a less aggressive brush suitable for the
oor to be cleaned or avoid working with extra
pressure function turned on.
The brush does not work, the red LED (81c) is on. The batteries are discharged. Charge the batteries.
The dirty water vacuuming is insufcient.
The recovery tank is full. Empty the tank.
The hose is disconnected from the squeegee. Connect.
The vacuum grid is clogged or the oat is
stuck closed.
Clean the grid or check the oat.
The squeegee is dirty or the squeegee blades
are worn or damaged.
Clean and check the squeegee.
The tank cover is not properly closed or the
gasket is damaged.
Close the cover or clean/replace the gasket.
The solution ow to the brush is insufcient.
The solution lter is dirty. Clean the lter.
The tank is dirty (the drain hole is clogged). Clean.
The Chemical Mixing System tank (optional)
is dirty/clogged.
Clean with the drain cycle.
The squeegee leaves marks on the oor.
There are debris under the squeegee blades. Remove the debris.
The squeegee blades are worn, chipped or
torn.
Replace the blades.
The squeegee has not been adjusted with the
handwheel.
Adjust it.
NOTE
If the machine has an optional battery charger installed, the machine cannot operate if the charger is not on board. In
case of battery charger malfunction, contact an authorised Service Center.
For further information refer to the Service Manual, available at any Nilsk Service Center.
SCRAPPING
Have the machine scrapped by a qualied scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Batteries
– Brushes/pads
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Nilsk Center especially when scrapping electrical and electronic components.
… 74 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO SCRUBTEC 545B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO SCRUBTEC 545B in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 7,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info