609423

Nilfisk-ALTO SCRUBTEC 337.2 Manual

60
Zoom out
Zoom in
Previous page
1/84
Next page
ENGLISH INSTRUCTIONS FOR USE
18 SCRUBTEC 337.2 - 9099872000
BRUSH CLEANING
NOTE
It is advisable to wear protective gloves when cleaning the brush because there may be sharp debris.
1. Remove the brush, as shown in Use chapter.
2. Clean the brush with water and detergent.
3. Check the brush bristles for integrity and wear; if necessary, replace the brush.
TANK, COVER AND VACUUM GRID CLEANING
1. Drive the machine to the appointed disposal area.
2. Check that the function selection knob (31) is turned to “0”
and disconnect the battery connector (7).
3. Remove the cover (A, Fig. 7), then clean and wash the
cover and the vacuum grid (B) with clean water.
4. Drain the water from the tanks (C) and clean them.
5. If necessary, disassemble the grid (B) and remove the oat
(D), than clean with care and reinstall.
6. Check the cover gaskets (E) and (F) for integrity.
NOTE
The gaskets (E) and (F) create vacuum in the tank
that is necessary for vacuuming the recovery water.
If necessary replace the gaskets by removing them from
their housings (G) on the cover (A). When assembling the
new gasket (E), install the joint (H) in the area shown in the
gure.
7. Check that the seating surface (I) of the gaskets (E) and
(F) is clean and adequate for the gasket themselves.
8. Check the vacuum duct (J) and the gasket (K), carefully
clean if necessary.
9. Close the recovery tank cover (A).
VACUUM SYSTEM GASKET CLEANING
NOTE
The gaskets (L) and (M) create vacuum in the
system that is necessary for vacuuming the recovery
water.
1. Drive the machine on a level oor.
2. Check that the function selection knob (31) is turned to “0”
and disconnect the battery connector (7).
3. Remove the tank assembly (C) and check the vacuum
system motor gasket (L) for integrity.
If necessary replace the gasket by removing it from its
housing.
4. Check the gasket (M) for integrity. If necessary replace the
gasket by removing it from its housing.
5. Clean with care and reinstall.
A
K
J
I
D
E
F
B
L
G
C
M
H
Figure 7
P100453
… 60 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO SCRUBTEC 337.2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO SCRUBTEC 337.2 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 6,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info