609422

Nilfisk-ALTO SCRUBTEC 234 C Manual

41
Zoom out
Zoom in
Previous page
1/60
Next page
USER MANUAL ENGLISH
SCRUBTEC 234C - 9099346000 11
AFTER USING THE MACHINE
1. Turn the main switch (2) to “0”.
2. Lift the brush and the squeegees with the pedal (25).
3. Disconnect the plug from the electrical mains and roll up
the cable.
4. Drain the solution tank (14) and clean it with clean water.
5. Drain the recovery tank (15) and clean it with clean water.
6. Check the hoses and replace them if necessary.
7. Remove the brush (20) and clean it with clean water.
8. Check the inner channels of the squeegees (18 - 19) and
clean them with clean water.
9. Check the solution lter (A, Fig. 5) and pre-lter (B). Clean
them with clean water and replace them if necessary.
10. Check the drain lter (C). Clean it with air and replace it if
it is clogged.
11. Store the machine in a clean and dry place.
Figure 5
P100516
TANK EMPTYING
WARNING!
At the end of every cleaning cycle, drain the recovery tank (15) to avoid that the dirty water is ejected from the
tanks (for example during an abrupt machine movement).
The recovery tank (15) is equipped with an automatic shut-off valve (24) to prevent the solution from entering the vacuum system.
When the vacuum ow is closed, the recovery tank must be drained. The machine cannot collect water when the valve is closed.
When the recovery tank (15) is full, empty it according to the following procedure:
1. Turn the main switch (2) to “0”.
2. Disconnect the plug from the electrical mains.
3. Lift the brush and the squeegees with the pedal (25).
4. Drive the machine to the appointed disposal area.
5. Manually remove the recovery tank and empty it.
6. Then, rinse the recovery tank with clean water.
MACHINE TRANSPORT
1. Roll up the power supply cable to the relevant holder on the handlebar.
2. Unlock the handlebar (8) with the lever (9).
3. Turn the handlebar until the end of stroke, above the machine cover.
4. Lock it.
WARNING!
Do not lift the machine if the handlebar is bent. Transport the machine by lifting it with the specied handgrips
(10) and (11).
… 41 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO SCRUBTEC 234 C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO SCRUBTEC 234 C in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info