609422

Nilfisk-ALTO SCRUBTEC 234 C Manual

40
Zoom out
Zoom in
Previous page
1/60
Next page
ENGLISH USER MANUAL
10 SCRUBTEC 234C - 9099346000
MACHINE OPERATION (SCRUBBING/DRYING)
1. Prepare the machine as shown in the previous paragraph.
2. Clean or vacuum the oor to remove any debris.
3. Connect the power supply plug (7) to the electrical mains.
WARNING!
Before connecting the power supply plug to
the electrical mains, check that frequency and
voltage, shown on the machine serial number
plate (26), match the electrical mains voltage.
4. Turn the main switch (2) to “I”, to turn on the brush motor.
5. Turn the switch (3) to “I”, to turn on the vacuum system
motor.
6. Turn the pump switch (4) to “I”, to turn on the solution ow
to the brush.
7. Press the pedal (Fig. 3) to lower the brush and squeegees
on the oor.
8. While keeping the hands on the handlebar, start the
machine by pressing the brush switches (6) and then start
scrubbing/drying the oor.
9. With the switch (5) adjust the solution ow according to the
type of cleaning to be performed.
• The switch is not pressed ( ): when the oors to
be cleaned are not very dirty; in this condition, the
machine autonomy is 10 minutes approximately.
• The switch is pressed ( ): when the oors to be
cleaned are dirty or very dirty; in this condition, the
machine autonomy is 7 minutes approximately.
10. For a better result, the machine must run at a low speed.
11. In case of tough dirt, wash the oor thoroughly by turning
the vacuum system switch (3) to “0”, then wash the oor
again and then collect the liquids by turning the vacuum
system switch (3) to ON.
CAUTION!
To avoid damaging the oor surface, do not use
the brush without the solution and, when the
machine is not operating, stop the brush.
12. At the end of the work, release the switches (6), turn
the main switch (2) to “0”, then lift the brush and the
squeegees with the pedal (Fig. 4).
Figure 3
P100514
Figure 4
P100515
… 40 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO SCRUBTEC 234 C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO SCRUBTEC 234 C in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info