609307

Nilfisk-ALTO MULTICLEANER 7-53 Manual

20
Zoom out
Zoom in
Previous page
1/29
Next page
21
MULTICLEANER 7-53
Original Instructions
ing plate/floor.
In pig fattening houses where the dirt typically sticks to the floor and
the dividing plates are typically high, we recommend you to accom-
plish the following washes:
• A dirty sty - washes 4, 5 and 6.
• A less dirty sty - washes 1, 2 (if you want a further cleaning, wash
3 may be added too).
In climate controlled livestock buildings and farrowing houses the
dirt is typically not so stuck, and as the dividing plates are not so
high, we recommend you to accomplish wash 1.
Typically the result of wash 1 alone will be satisfactory. As an alter-
native washes 2 and maybe 3 can be added.
You should consider the required number of washes carefully and
not accomplish more than 3 washes, as the efficiency of the robot
will hereafter drop sharply and thus the operational costs will in-
crease more than the usefulness of the washes.
You are advised to remove the remaining dirt manually immediately
upon the finishing of the robot.
Change of washing sequence during automatic wash
If you want to clean a very dirty sty in a big fattening house, select 6
washes.
When the programming has been finished and the arm has started
to turn, press the emergency button. Then the robot will go into
emergency stop fault mode.
When the robot is in emergency stop fault mode, it is possible to
change the number of accomplished washes by means of and 
Change number of accomplished washes to 3. Then turn the emer-
gency stop button until released and then push and the robot
will now continue with wash 4 and subsequently washes 5 and 6,
whereafter it will stop.
Example:
1. Are the stys in a pig fattening house very dirty (see chart on the
opposite side).
2. Program the robot as usually; set number of washes 6.
3. Push one of the red emergency stop buttons on the robot.
4. Use and to select the number of accomplished washes; se-
lect 3 (The light on the display will flash between number of ac-
complished washes and emergency stop faults).
5. Turn the red emergency stop button to release it.
6. Push arrow key .
7. The robot will start with wash 4.
Accidental interruptions
It is at all times possible to change the wash the robot is doing by
pushing the emergency stop button and using the arrow keys as
described above.
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO MULTICLEANER 7-53 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO MULTICLEANER 7-53 in the language / languages: English as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info