619204

Niko 350-20054 Manual

21
Zoom out
Zoom in
Previous page
1/32
Next page
350-20054 / 350-20055
21
EN
3.2. Settings
3.2.1. General
At delivery, the light sensor parameters are set as follows (factory settings):
sensor mode automatic
sensitivity high
LED motion indicator off
Use DIP switches 1 and 2 to set the presence detector to the desired test mode and activate the LED motion indicator.
To set the sensitivity, use DIP switches 3 and 4. Figure 7 shows how to set the DIP switches for the desired sensitivity
of the light sensor (minimum, low, high, maximum).
3.2.2. Test modes
The presence detector has two test modes: a test mode for the lux value and a test mode for the motion detector operation.
a) Test mode for the lux value: measuring the daylight level
Set DIP switches 1 and 2 to ON. The lighting is now switched off.
Slowly turn the LUX key clockwise (towards maximum) until the LED indicator illuminates. The lux setting is then
equal to the daylight level the light sensor is measuring. If there is sufficient daylight in the room, turn the LUX key
counterclockwise until the LED indicator switches off. Leave the LUX key in this position.
If the LUX key is turned counterclockwise, the lighting switches off when there is less daylight.
If the LUX key is turned clockwise, the lighting switches off when there is more daylight.
Finally, reset DIP switches 1 and 2 to OFF.
b) Test mode for the motion detector operation
Set DIP switch 1 to OFF and DIP switch 2 to ON. The lighting is switched on for five seconds. The LED motion
indicator indicates that the motion detector is activated.
Attention: The walking is not affected by daylight.
Finally, reset DIP switch 2 to OFF.
3.2.3. LED motion indicator
Set DIP switch 1 to ON and DIP switch 2 to OFF to activate to LED motion indicator. The LED indicator remains illuminated
as long as motion is detected.
3.2.4. Detection range
If the presence detector is mounted at a height of 2.5 m, it detects movement within a diameter of 20 m in a 360° zone. This
presence detector has a lens area with a diameter of 5 m and more than 618 fields, which guarantees optimal registration
of even the smallest body movements.
If a section of the detection area is to be excluded from detecting any motion, cover the sensor lens using the cover cap
supplied. This allows the maximum range to be reduced from 20 m to 12 m, 5 m or 3 m. The detection angle of 360° can
be decreased in steps of 45° (fig. 7).
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Niko 350-20054 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Niko 350-20054 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info