641187
129
Zoom out
Zoom in
Previous page
1/150
Next page
Niagara 2200 User Guide
ViewCast 123
Setting
Explanation
lower than -3 and higher than 3 are usually not used, but could
be if so desired.
LookaheadFrames
This value is the amount of frames the encoder keeps in its
buffers to perform various calculations. The higher this value,
the better the quality and the closer to a constant bit rate the
encoded video will be; however the CPU load is higher and the
latency from the source through the encoder is also higher.
Setting this to 0, depending on the encoder, will provide the
lowest latency possible.
NoiseReduction
This value performs adaptive noise reduction, estimates film
noise based on the value and attempts to remove the noise by
dropping small details before quantization (100 to 1000 for de-
noising). As a result, using Noise Reduction can make the
encoded video look smoother, but with much less detail.
QuantizerMax
This value sets the maximum for the quantizer. The range is 1
to 51 with 51 being the highest and least complex quantizer
available. The value 51 provides the most encoding, thus
making the picture quality farthest away from the original.
However, lowering this value increases CPU load, in some
cases considerably. Also, this value affects the bit rate with 51
keeping closer to a constant bit rate, while lower values cause
the bit rate to vary.
QuantizerMin
This value sets the minimum quantizer ever used in the
encoder. The lower the quantizer, the closer the encoded
video is to the original. For most video, any value below 10
appears almost the same as the original video.
ReferenceFrames
This value is the number of previous frames each P-frame can
use as a reference. More reference frames increase the quality
of the encoded video but increases the CPU load. Each
increase, however has reduced benefit and takes longer to
encode.
SceneChangeDetectThreshold
Higher values of this setting cause the encoder to detect more
scene changes. For example, a fast action movie that has many
scenes can have this value set lower than a newscast, but the
newscast video quality may suffer a bit at the same value. 60 is
a good default for most applications. 0 turns off scene change
detection, but this is not recommended. Higher values also
increase CPU usage.
TrellisRDQuantization
This value performs Trellis quantization to increase the visual
quality of the encoded video: the higher the value, the better
the qualities of the video, but the higher the CPU load. This
value can also improve visual quality at lower bit rates.
However, settings above 0 are applicable for Main or High
Profile in the Custom Presets.
129


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Niagara 2200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Niagara 2200 in the language / languages: English as an attachment in your email.

The manual is 4,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Niagara 2200

Niagara 2200 Quick start guide - English - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info