695255

Nestor Martin HARMONY III MF - 39696 Manual

34
Zoom out
Zoom in
Previous page
1/44
Next page
34
WHAT ARE THE DRAW BACKS OF DAMP WOOD?
Damp wood has far Iess heating power, this lowers the combustion temperature of
the fire therefore, the output. It is difficult to light, burns badly and gives off smoke. Above all
the use of damp wood causes the formation of deposits (tarring and soot staining) in the
chimney flue and the glass door.
WHAT IS TARRING AND SOOT STAINING IN THE CHIMNEY?
When the smoke arrives in the chimney at low temperature, part of the water vapour which
they convey condenses. The heaviest constituants are deposited on the inside of the flue. this is
TARRING. the mixture oxidises in the air and forms brownish patches. That is SOOT STAINING. Four
essential points for avoiding these drawbacks, use dry wood, use a stove designed for wood, connect
it to a chimney with thick walls and of suitable cross-section (size and height), ensure the connecting
pipes are as short as possible. (Horizontal pipes should be no mort than 6" 150mm).
FLUE GAS TEMPERATURE
The most important aspect of stove operation is maintaining a high combustion
temperature. If the combustion of the fuel is at the correct temperature, most of the soots and
tars (hydrocarbons) are burned. These hydrocarbons when not burned can be seen as tar
and creosote deposits on the internal surfaces of the stove, glass and chimney surfaces. To
assist in maintaining these temperatures a surface maunted, stove thermometer is a must.
It is recommended that you heat your stove to at least 400°F before reducing the air
controls. After reloading this procedure should always be carried out. If the wood is not quite
as dry as it should be, to assist for a short period, smokeless coal can be added with the wood
to raise the combustion temperture.
STORAGE TIME FOR WOOD
Wood supplied in ready-cut lengths stored immediately under a ventilated shelter
dries quicker than wood stocked in high piles. Quarters (split wood) dry quicker than round
logs. Wood which is too small to split must be drained, by removing some of the bark. Round
logs left in the open for more than a year end up rotten. The drying time for the fire wood
must be at Ieast 18 months to 2 years. This period can be shortened (12 to 15 months) if the
wood is cut to the right length and immediately stored under a ventilated shelter.
MAINTENANCE OF THE GLASS.
Properly operated, your glass doors will not get coated with thick tar like
conventional stoves. If this does occur you may have to resort to using a glass
cleaner. However by using the correct dry fuels and or smokeless coal , much of
the tar on the glass will burn clean, when the appliance is run at high temperature.
Clean the ceramic glass when cold using commercial products sold for the purpose or
warm water with a drap of vinegar.
… 34 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nestor Martin HARMONY III MF - 39696 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nestor Martin HARMONY III MF - 39696 in the language / languages: English, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info