695255
31
Zoom out
Zoom in
Previous page
1/44
Next page
31
AIR SUPPLY TO APPLIANCE.
A room air entry opening or openings is or are needed. These must have a total
free area of at Ieast 550mm
2
per kW of rated output above 5kW. Where a flue
stabiliser is used the total free area should be incraesed by 300mm
2
for each kW
of rated output.
LIGHTING AND OPERATING WITH WOOD
Place tightly rolled paper, wond kindling or firelighters together with some small
logs on the oscillating grate. Light the paper or firelighters. Open air wash control
(n° 1), Ieave the stove door slightly ajar, open thermostat (nº.2).
Open the direct draught damper (3) to warm the chimney (pull the handle to the
right)
After about 10 minutes (more time for poorly drawing chimneys) when combustion is well
under way, close the direct draught damper (nº 3) (push the handle to the left) close the
thermostat (n° 2). Adjust the tempo of the fire by means of the air wash control (n° 1).
OPERATION WITH WOOD
The air wash control n° 1 enables the tempo of the stove to be adjusted by the size of the
intake opening. With the tool provided the control can be adjusted to the heat output
required.
OVER NIGHT BURNING
If you fill your appliance with wood and close all air supplies, you will, no doubt,
easily achieve overnight burning though it is probable that the glass door will
become dirty. To keep the glass clean, we recommend you do not shut the
damper completely but to leave it slightly open, depending on how the chimney
draws, to achieve slow burning for a maximum of 10 hours. With a good drawing
chimney the air wash control n° 1 will need to be closed further than with poor
drawing chimneys.
FUELLING THE STOVE WITH WOOD
It possible use the loading door.
To prevent smoke blowing into the room follow these recommendations:
Firstly open air wash control n°1, allow fire to recover.
Close air wash control n° 1, and open door open the damper (3). Rake the embers towards
the front of the stove and spread evenly. If there are logs only partially burned rake these to
the front of stove.
Feed the logs to the embers. Load logs evenly across the base being cautious not to place
wood in front of the rear edge of the log guard.
Open the air wash control n° 1 to its maximum, open the stove door a fraction and leave to
burn for 5 to 10 minutes. Then close the stove door close the damper (3). Adjust the air wash
control n° 1 depending on the tempo of the stove required.
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nestor Martin HARMONY III MF - 39696 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nestor Martin HARMONY III MF - 39696 in the language / languages: English, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info