170484

Nec express5800 tm800 nl Manual

204
Zoom out
Zoom in
Previous page
1/266
Next page
User Guide
204
www.nec-computers.com
■ Did you perform any keyboard or mouse operation immediately after you started
the server?
- If you perform any keyboard or mouse operation immediately after start-up,
POST may accidentally detect a keyboard controller error and stops proceeding.
In such a case, restart the server once again. Do not perform any keyboard or
mouse operation until the BIOS start-up message appears when you restart the
server.
■ Does the server contain appropriate memory boards or PCI devices?
- Operation of the server with unauthorized devices is not guaranteed.
Fail to access to internal or external devices (or such devices fail to operate):
■ Are cables properly connected?
- Make sure that the interface cables and power cord are properly connected. Also
make sure that the cables are connected in the correct order.
■ Is the power-on order correct?
- When the server has any external devices connected, power on the external
devices first, then the server.
■ Did you install drivers for connected optional devices?
- Some optional devices require specific device drivers. Refer to the manual that
comes with the device to install its driver.
■ Is BIOS configuration correct?
- Some devices connected to the serial or parallel port may require I/O port
address or operation mode settings. Refer to the manual that comes with the
board for details to make correct settings.
The Power switch and sleep features are disabled:
■ Is the server in Secure mode?
- In the Secure Mode, the Power switch and sleep feature are disabled. To release
the Secure mode, enter the password specified with the BIOS Setup utility.
The keyboard or mouse fails to operate:
■ Is the cable properly connected?
- Make sure that the cable is connected to the correct connector on the rear of the
server.
- The keyboard or mouse does not operate if it is connected when the server is
powered (not applicable to USB devices). Power of the server first and connect
it properly.
■ Are the server drivers installed?
… 204 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nec express5800 tm800 nl at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nec express5800 tm800 nl in the language / languages: English as an attachment in your email.

The manual is 2,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info