512549
11
Zoom out
Zoom in
Previous page
1/19
Next page
11
MULTI 3100 Installation and Operation Manual
NAVMAN
6 Temperature
Temperature is measured by a sensor in the speed
transducer.
6-1 Set temperature units
The units can be either °C or °F:
Press until the temperature is displayed,
then hold until the units change.
6-2 Calibrate temperature
The unit is factory calibrated and should not normally
need calibrating. To calibrate:
1 Measure the water temperature near the speed
transducer.
2 Press
+ several times until the
Temperature Calibration screen is displayed:
3 Press
or to change the temperature to
the value measured in step 1 above.
4 Press
.
Water
temperature
7 Countdown timer
You can adjust the countdown timer to start counting
down between one and ten minutes, in increments
of one minute. The factory default start time is 10
minutes. When the timer is counting down, the
countdown timer symbol flashes and the time
remaining is displayed in minutes and seconds:
The beeper sounds and any external beepers or
lights operate:
Four beeps at four minutes to go.
Three beeps at three minutes.
Two beeps at two minutes.
One beep at one minute.
Ten beeps at the end; the last beep is longer
and marks the end of the countdown.
In each case, the end of the last beep marks the
exact minute.
Timer
counting
down
Countdown
timer symbol
flashes
7-1 Start countdown timer
The timer starts at the start time (to adjust the start
time, see section 7-3).
1 Press
until the countdown timer is
displayed.
2 Press
+ . The timer displays On briefly
and starts counting down from the start time.
Timer
start time
is 9 min
7-2 Stop and reset countdown timer
1 Press until the countdown timer is
displayed.
2 Press
+ . The timer stops and the time
resets to the start time (see section 7-3).
7-3 Adjust start time
1 Press + several times until the
Countdown Timer Start Time screen is displayed:
2 Press
or to set the start time in minutes.
3 Press
. The timer does not start now (to start
the timer, see section 7-1).
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman Multi 3100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman Multi 3100 in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Navman Multi 3100

Navman Multi 3100 User Manual - German - 18 pages

Navman Multi 3100 User Manual - Dutch - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info