512540
12
Zoom out
Zoom in
Previous page
1/13
Next page
15NAVMAN M100 User Manual
Speed Calibration
Speed Comparison Method
Use the following sequence to adjust the speed
displayed to match that of another craft or the
speed displayed on a GPS receiver.
Follow the Secondary Functions chart to reach
Speed Calibration mode.
To increase reading press the key.
To decrease reading press the
key.
To enter the calibration setting into memory and
exit press the
key.
Note:
When the speed calibration is adjusted the
trip log and the average speed will be reset.
Log Calibration Method
Set the log to zero and travel a known distance
between two points.
If there is any tidal current,
you should travel the course in both directions
and use twice the known distance. Try to avoid
the situation where the current is flowwing at
right angles to the course, or if this cannot be
avoided, make sure that the boat speed is at
least ten times the speed of the current.
You may calculate a correction factor as follows:
Known distance
correction factor =
distance from log
For example, if you have travelled over a known
distance of 1 mile but your log reading is 0.80,
the correction factor is 1.25. Therefore, your
correct boat speed will be the indicated speed
multiplied by 1.25.
Enter the simulation mode by holding down the
key at power up, When speed is selected in
the simulator mode the display will indicate a
fixed calibration speed. With the factory default
calibration this speed will be 10.0 knots.
Follow the Secondary Functions chart to reach
Speed Calibration mode.
Use the
to set the displayed speed to the
new value. For our example, assuming we
started with the factory default calibration, this
new speed would be 10.0 x 1.25 which is 12.5
knots.
To enter the calibration setting into memory and
exit press the
key.
To exit simulation mode, remove the power and
then hold the key at power up
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman Multi 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman Multi 100 in the language / languages: English as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info