663850
9
Zoom out
Zoom in
Previous page
1/34
Next page
G-PILOT 3100 Installation Manual
NAVMAN
9
3-2 Installation guide
This is a general guide for locating and wiring the parts of the G-PILOT 3100. The instructions for
a particular part may have additional requirements.
3-2-1 Location guide
Do not mount any part where it can be used
as a handhold, where it will interfere with
the operation of the boat or where it might
be submerged.
Do not mount any part where it will interfere
with launching or retrieving the boat.
Do not mount any part within 0.5 m (20")
of the plane of a radar antenna.
Mount the compass and gyro:
At least 1 m (3 ft) away from sources
of electrical signals or noise, such as
the batteries, high-current cables,
other boat cables, engines, uorescent
lights, power inverters, radio or radar
transmitters and antennas.
At least 1 m (3 ft) away from equipment
containing a magnet, such as a
compass.
3-2-2 Wiring guide
The G-PILOT 3100 has two kinds of cables:
The heavy-duty power supply and steering
drive usually require high-current cables:
Select the wire gauge from the wire size
table (see section 3-4-2).
Fit high-current cables at least 1 m (3
ft) away from other electronic devices in
the boat.
Keep the cables as short as possible.
Twin 2 mm (#14) cable is supplied with the
G-PILOT 3100 and can be used for the high
current cable if its gauge is suitable.
All the other cables are low-current:
Fit low-current cables at least 1 m (3 ft)
away from sources of electrical signals
or noise, such as the high-current cables,
other boat cables, engines, fluorescent
lights, power inverters and radio or radar
transmitters and antennas.
If the cable for the rudder feedback unit,
compass or gyro is too long, do not shorten
the cable; instead coil the cable up near the
main control unit.
The cable for the rudder feedback unit,
compass or gyro can be extended by
adding a 10 m (33 ft) extension cable and
coupling connector. Do not t more than
one extension cable to each unit.
When tting any type of cable:
Do not crush, pinch or strain the cable.
Secure the cable at regular intervals.
Ensure no connectors or exposed terminals
are in the bilge.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman G-PILOT 3100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman G-PILOT 3100 in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Navman G-PILOT 3100

Navman G-PILOT 3100 User Manual - English - 36 pages

Navman G-PILOT 3100 User Manual - German - 33 pages

Navman G-PILOT 3100 Installation Guide - German - 32 pages

Navman G-PILOT 3100 User Manual - Dutch - 34 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info