470017
17
Zoom out
Zoom in
Previous page
1/25
Next page
FISH 4100 Installation and Operation Manual NAVMAN
17
Use this menu to
calibrate the water
temperature and the
boat speed.
Select MAIN MENU -
SETUP - INSTALL -
CALIBRATION to
display the calibration
menu.
Calibrating the
Temperature
The factory settings
should be sufficiently
accurate for normal usage. However to calibrate the
temperature readout, first measure the water
temperature.
Then, to calibrate the setting, select TEMPERATURE
then press
to display the temperature readout box.
Press
or
to increase or decrease the value to
match the measured temperature.
(To change the temperature units between °F
(Fahrenheit) or °C (Celsius), use the SETUP - UNITS
menu (see section 4-2).
Calibrating the Speed
Use this to calibrate the boat's speed and log.
Calibration may be required because different hull
shapes have different flow characteristics.
Obtain an accurate measurement of the boat's speed
from a GPS receiver; by following another boat
travelling at a known speed; or by making a timed
run over a known distance.
Note that for accurate calibration:
· The speed from a GPS receiver should be
greater than 5 knots.
· The speed from another paddlewheel
transducer should be between 5 and 20 knots.
· Best results are achieved in calm conditions
where there is minimal current (best at high or
low tide).
Use
or
to highlight the SPEED option, then press
to display the speed readout box. Press
or
to
increase or decrease the readout to match the
independent speed value.
Important
This option resets all of the following settings and
resets them to the manufacturer’s default settings.
Settings relating to water temperature and boat
speed are for the FISH 4150 only. Speed and distance
are related. For example, if knots are chosen as the
speed units, then distance is always measured in
nautical miles.
To reset the fishfinder to the manufacturer's default
settings, power off the fishfinder. Then hold
and
power on while holding it.
The message “RESET TO FACTORY DEFAULTS?”
appears. If “YES” is highlighted, do nothing and the
fishfinder resets to the default settings. Otherwise,
press
or
to select YES.
GENERAL
Auto Gain ....................................................... ON
Auto Range .................................................... ON
Manual Gain .......................................................5
Bottom Lock ................................................... ON
Key Beep ........................................................ ON
Contrast ............................................................. 6
Backlighting ........................................................6
4-8 CALIBRATION menu (FISH 4150 only)
4-9 Resetting to Factory Defaults
UNITS
Temperature ..................................................... °F
Depth ........................................................... Feet
Speed .............................................................. KN
Distance ......................................................... NM
ALARMS
Shallow Alarm .............................................. OFF
Shallow Alarm Value ..................................... 10 ft
Deep Alarm .................................................. OFF
Deep Alarm Value ......................................... 60 ft
Fish Alarm .................................................... OFF
Temp. Change Alarm ................................... OFF
Temp. Change Alarm Value........................ 5.0 °F
Temp. Alarm ................................................. OFF
Temp. Alarm Value ...................................... 80 °F
Low Battery Alarm ........................................ OFF
Battery Alarm Value .............................. 11.5 Volts
FISH SYMBOL .......................................
INSTALL
Keel Offset ................................................... 0.0 ft
17


Need help? Post your question in this forum.

Forumrules
1

Forum

navman-fish-4100

Reset search

  • what does the low battery alarm mean on my fishinder Submitted on 21-7-2022 at 21:05

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman FISH 4100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman FISH 4100 in the language / languages: English as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Navman FISH 4100

Navman FISH 4100 Usermanual and installation guide - German - 27 pages

Navman FISH 4100 Usermanual and installation guide - Dutch - 25 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info