Manual Napoleon Triumph 410 (page 9 of 56) (English, German, French)

637885

Zoom out

Zoom in

1/56

www.napoleongrills.c

Ligh

ts: T

o r

move the lens from the light housing, insert a at screwdriver p between the lens and the

hous

ing and r

ock it g

tly

. Do not touch the halogen bulb. The oil from your ngerps will reduce the

life of the bulb. To clean the lens, rst soak it in hot soapy water, then clean with a rag and non abrasive

cleaner. To reinstall the lens, simply snap it back into the housing.

Tube Burner: The burne

rs are made from heavy wall 304 stainless steel, but extreme heat and a corrosive

envi

ronment can c

ause surface corrosion to occur. This can be removed with a brass wire brush.

CAUTION!

Beware of Spider

Spiders and insects are aracted to the smell of propane and natural gas. The burner is equipped with an

insect screen on the air shuer, which reduces the likelihood of insects building nests inside the burner

but does not enrely eliminate the problem. A nest or web can cause the burner to burn with a so

yellow or orange ame or cause a re (ashback) at the air shuer beneath the control panel. To clean the

inside of the burner, it must be removed from the gas grill: Remove the screw that aaches the burner to

the back wall. Slide the burner back and upwards to remove. Cleaning: Use a exible venturi tube brush

to clean the inside of the burner. Shake any loose debris from the burner through the gas inlet. Check the

burner ports and valve orices for blockages. Burner ports can close over me due to cooking debris and

corrosion, use an opened paperclip or the supplied port maintenance bit to clean them. Drill out blocked

ports using this drill bit in a small cordless drill. The ports are easier to clean if the burner is removed from

the grill, but it can also be done with the burner installed. Do not ex the drill bit when drilling the ports,

as this will cause the drill bit to break. This drill is for burner ports only, not for the brass orices (jets)

which regulate the ow into the burner. Take care not to enlarge the holes. Ensure the insect screen is

clean, ght, and free of any lint or other debris.

Reinstallaon: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when

installing.

WARNING!

Accumulated grease is a r

e hazard.

Drip Pan: Clean the drip pan frequently (every 4 – 5 uses or as oen as required) to avoid grease buildup.

Grease and excess drippings pass through to the drip pan, located beneath the gas grill and accumulate in

the disposable grease tray below the drip pan. To access the disposable grease tray or to clean the drip

pan, slide the drip pan free of the grill. Never line the drip pan with aluminum foil, sand or any other mate-

rial as this could prevent the grease from owing properly. The pan should be scraped out with a puy

knife or scraper. Replace the disposable grease tray every 2 – 4 weeks, depending on gas grill usage. For

supplies, see your Napoleon Gas Grill dealer.

Cleaning The Outer Grill Surface: Do not use abrasive cleaners or steel wool on any painted, porcelain or

stainless steel parts of your Napoleon Grill. Doing so will scratch the nish. Exterior grill surfaces should be

cleaned with warm soapy water while the metal is sll warm to the touch. To clean stainless surfaces, use

a stainless steel or a non-abrasive cleaner. Always wipe in the direcon of the grain. Over me, stainless

steel parts discolor when heated, usually to a golden or brown hue. This discoloraon is normal and does

not aect the performance of the grill. Porcelain enamel components must be handled with addional

care. The baked-on enamel nish is glass-like, and will chip if struck. Touch-up enamel is available from

your Napoleon Grill dealer.

WARNING!

Hose: Check for abrasions, melng, cuts, and cr

acks in the hose. If any of these

condions exist, do not use the gas grill. Have the part replaced by your Napoleon Gas Grill dealer or

qualied gas installer.

WARNING!

When reinstalling the burner a

er cleaning it is very

important that the valve/orice enters the burner tube before lighng your

gas grill. If the valve is not inside the burner tube a re or explosion could

occur.

Aluminum Casngs: Clean casngs periodic

ally with warm soapy water. Aluminum will not rust, but high

temperatures and weathering can cause oxidaon to occur on aluminum surfaces. This appears as white

spots on the casngs. To renish these areas, clean rst and sand lightly with ne sandpaper. Wipe the

surface to

remov

e any residue and paint with high temperature barbecue paint. Protect surrounding

areas from over-spray. Follow the manufacture’s direcons for curing.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Napoleon Triumph 410 in the language / languages: English, German, French as an attachment in your email.

The manual is 13,63 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Napoleon Triumph 410 Manual

Product: