707496
7
Zoom out
Zoom in
Previous page
1/29
Next page
5
Installation - Getting Started
2.5 External Screen Setup
If an external display is used, the UnitiServe-SSD external
display setup may need to be modified. Navigate, via the
System menu, to the System Settings menu. Select and
save the desired External Display Theme, External Display
Aspect Ratio, External Display Mode and TV System. Initially
disable the Screen Saver (found on System Setup page 1).
Note: The External Display Mode setting configures the
external display for use with either an external touch
screen or a remote handset. In touch screen mode, four
shortcut buttons are displayed on the right of the screen
that correspond to the home, browse, find and back keys
on the remote handset. The on screen shortcut buttons
can only be accessed from the touch screen so are not
shown in remote control mode.
Note: Once you have become used to the interface and
are familiar with its functions the screen saver can be
re-enabled.
2.6 First Use
Before attempting to rip a CD you must ensure that the
necessary Network Attached Storage (NAS) disk drive is
appropriately configured, connected to the network, and
switched on. Section 7 of this manual describes the use
and configuration of external storage.
To rip a CD, insert the CD into the transport slot. The ripping
process will begin automatically. When CD ripping is
complete UnitiServe-SSD will eject the CD automatically.
See Section 6 for further information on ripping CDs.
Only CDs owned personally should be ripped. Ripping a
borrowed CD may violate copyright law.
Note: Although UnitiServe-SSD contains a small internal
music database, to be able to identify a CD and
download its associated data during the ripping process, it
must be connected to a working internet connection.
2.7 Software Upgrade
Software upgrade CDs will occasionally be released
for UnitiServe-SSD. New software is installed simply by
inserting the upgrade CD in the transport. The software
upgrade process will commence automatically. As part
of the upgrade process UnitiServe-SSD will eject the CD
and re-boot. The upgrade process is complete once the
interface returns to the Home Menu.
Note: Any specific instructions included with the upgrade
CD should be followed carefully.
Never switch off UnitiServe-SSD from the rear panel power
switch or unplug it from the mains supply while a software
upgrade process is underway.
2.8 Switching Off
Switching off UnitiServe-SSD from its rear panel power
switch is not normally necessary unless it is to be
un-installed. It can be put into shutdown mode by
touching the front panel logo for five seconds. UnitiServe-
SSD may take up to one minute to enter shutdown mode
during which time the logo will flash. Wait until the logo
stops flashing before switching off UnitiServe-SSD from the
rear panel power switch.
Never switch off UnitiServe-SSD from the rear panel power
switch or unplug it from the mains supply unless it is in
shutdown mode.
To switch UnitiServe-SSD back on from shutdown mode, the
power switch must be switched off and on again.
2.9 Data Backup
UnitiServe-SSD does not incorporate an integral backup
disk drive and we strongly advise that you protect your
stored music by implementing a regular backup to a
Network Attached Storage (NAS) hard disk drive.
Implementing regular backups to a network share can be
set up via the UnitiServe-SSD System menu. This is described
in Section 4.8.4.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Naim UnitiServe at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Naim UnitiServe in the language / languages: English as an attachment in your email.

The manual is 2,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Naim UnitiServe

Naim UnitiServe User Manual - English - 31 pages

Naim UnitiServe User Manual - German - 29 pages

Naim UnitiServe User Manual - German - 31 pages

Naim UnitiServe User Manual - French - 32 pages

Naim UnitiServe User Manual - Italian - 29 pages

Naim UnitiServe User Manual - Italian - 31 pages

Naim UnitiServe User Manual - Spanish - 31 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info