602921
6
Zoom out
Zoom in
Previous page
1/66
Next page
1 INPUT
· Each of the seven independent power ampliers within the T 977
has its own signal input connector.
· Connect the output from a preamplier or processor to this set of
inputs.
For optimum heat dissipation in an AV surround system, the following
audio channel allocations are recommended:
Channel 1 = Front Left speaker
Channel 2 = Surround Left speaker
Channel 3 = Surround Back Left speaker
Channel 4 = Center speaker
Channel 5 = Surround Back Right speaker
Channel 6 = Surround Right speaker
Channel 7 = Front Right speaker
NOTES
· Always turn OFF the T 977 and other components in the system before
connecting or disconnecting anything to the INPUT sockets.
· Before switching ON the T 977 from standby mode for the rst time,
make sure all input level controls are set to minimum (MIN) level
position. This prevents inadvertently beginning a session at excessive
volume.
2 INPUT LEVEL CONTROL
· The T 977 is equipped with separate input level controls for each
channel.
· Before switching ON the T 977 from standby mode for the rst time,
make sure all input level controls are set to minimum (MIN) level
position.
Level Matching
In a surround sound or system with more than one set of speakers,
dierences in levels can occur due to varying ineciencies among the
speakers. In case your preamplier or processor also has individual trims
for each channel, set these to neutral or mid position (usually marked
as 0dB). Adjust the INPUT LEVEL CONTROL so that the speakers driven
by the T 977 have the correct level compared to the other speakers,
judging from your listening position.
Extended Volume Control Range
Many systems have so much voltage gain that the speakers (or your
ears) are overdriven at any volume control setting higher than 11 or
12oclock. As a result you are conned to using only the lower half
of the volume control’s range, where adjustments are imprecise and
where channel balance errors tend to be greater.
If the input level is reduced, you can turn up the volume control of
your processor or preamplier, making more eective use of its range.
(Suggestion: Adjust the input level controls so that your preferred
maximum sound levels usually occur at about 2 or 3 oclock on the
volume control.) As an added benet, this procedure suppresses any
noise produced by the preamplier’s high level circuitry (e.g. any
residual hum or hiss that does not go away when the Volume is turned
down).
IDENTIFICATION OF CONTROLS
REAR PANEL
ATTENTION!
Ensure that the T 977 is unplugged before making any connections. It is also advisable to power-down or unplug all associated components while making
or breaking any signal or AC power connections.
© NAD T 977
FUSE
MAINS IN
SPEAKER
SPEAKER
SPEAKER
SPEAKER
SPEAKER
SPEAKER
SPEAKER
INPUT
+12V TRIGGER IN
ON OFF
C HA NNE L 7
FR O NT R
C HA NNE L 6
C HA NNE L 5
C HA NNE L 4
C HA NNE L 3
C HA NNE L 2
S UR R R
SU R R -B R
CE NT E R
S UR R -B L
S UR R L
C HA NNE L 1
FR O NT L
FRONT R
SURR R
SURR-B R
CENTER
SURR-B L
SURR L
CHANNEL 1
FRONT L
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
MAX
MIN
MAX
MIN
MAX
MIN
MAX
MIN
MAX
MIN
MAX
MIN
MAX
MIN
CHANNEL 7
CHANNEL 6
CHANNEL 5
CHANNEL 4
CHANNEL 3
CHANNEL 2
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
SOFT
CLIPPING
1 2
83 4 5 6 7
6
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ
T977_eng_OM_v04.indd 6 17/04/2012 9:28am
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NAD T977 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NAD T977 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 3,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info