Manual NAD T 775 (page 23 of 46) (English)

602917

Zoom out

Zoom in

1/46

The SPL meter should be placed at the primary listening position, at

approximately the height of the seated listener’s head. A tripod is helpful

but with a little duct tape almost anything — a pole lamp, music-stand,

or ladder-backed chair, for example — can do as well. Just be sure that no

large acoustically reective surfaces obstruct or are near the microphone

element.

Orient the meter with its microphone (usually at one end) pointing straight

up toward the ceiling (not toward the speakers) and ensure that “C”

weighting scale is selected. Set the meter to display 75 dB SPL. On Radio

Shack meters, this necessitates either setting the meter to its 80 dB range

and taking your readings at the -5 point or selecting the 70 dB range and

reading at the +5 point.

SETTING SPEAKER LEVELS AT TEST MODE

While at ‘Speaker Levels’ menu, press the HTR 3 remote’s ‘Test’ key activating

the T 775’s Speaker Levels balancing test signal . You will hear a “surf” sound

as you step through your speakers (‘test’ appears to the right side of the

current speaker), beginning with the Front Left. If you do not hear the test

signal, check your speaker connections or your ‘Speaker Setup’ OSD menu

settings.

Use the remote’s keys to adjust the loudness of the noise output from

the currently playing channel to the required level (it’s usually simplest to

begin with the Front Left). As you cycle the test signal around the speakers,

the OSD will highlight the currently playing channel. The “level oset”

reading on the right will change by 1 dB increments; ±12 dB adjustment is

available. Press ‘ENTER’ to adjust the next speaker.

NOTE

 Ifyouarebalancinglevels“byear”,chooseonespeaker—usuallythe

center—asareferenceandadjusteachoftheothersinturnto“soundas

loud”asthereference.Besurethatyouremainintheprimarylistening

position while balancing all channels.

To produce the same SPL meter reading (or subjective loudness), use the remote’s

keys to adjust each speaker.

NOTES

• Allspeakersmustbeintheirnallocationsbeforelevel-setting.

• Yoursubwoofer(ifany)shouldbesetwithitsintegralcrossoverdefeated,

orifundefeatable,settoitshighest-possiblefrequencyifyouareusing

theT775'sSubwooferoutput.Finalsubwoofer-leveladjustment“by-ear,”

usingmusicandlmsoundmaterial,isfrequentlyuseful.

• Duetotheeectsofroomacoustics,matched-pairspeakers(front;

surround;back)willnotalwayscalibratetoexactlythesameleveloset

readings.

You can exit ‘Test’ mode at any time by pressing key, bringing you back to

‘Speaker Setup’ menu. You can also press the ‘TEST’ key to discontinue the

‘Test’ mode.

SPEAKER DISTANCE

Your system’s speaker distance settings are a subtle but important

renement of your setup. Informing the T 775 of the loudspeaker-to-listener

dimensions of each speaker automatically imposes the correct delays,

optimizing imaging, intelligibility and surround-sound ambience. Enter your

dimensions with precision within about 1 foot (30 cm).

SETTING SPEAKER DISTANCE

While at ‘Speaker Distance’ menu, use the keys to individually set Front

Left, Center, Front Right, Surround Right, Back Right, Back Left, Surround

Left and Subwoofer to the distance measuring from your principal listening

position to the front surface of their corresponding loudspeakers. Distance

can be set up to 30 feet or 9.1 meters Distance can be displayed as feet or

meters selectable at the ‘Unit of Measure’ item.

ADjUSTING THE VOLUME

In addition to the Volume knob, use the HTR 3’s VOL to adjust the “master

volume” of the T 775 raising or lowering the channels altogether. A momentary

keypress will change the master volume by 1 dB increments. If you hold down

VOL , the master-volume change will “run-on” until the key is released.

Since recordings vary considerably in overall average level, there is no

imperative to listen at any particular master-volume setting. A setting of

-20 dB may sound “as loud” from one CD or DVD as -10 dB does from another.

The T 775 will power-up from Standby mode at whatever master volume

setting was last used; however, if the prior setting was greater than –20 dB,

the T 775 will power up at –20 dB. This prevents inadvertently beginning a

session at excessive volume.

OPERATION

USING THE T 775  SETUP MENU

ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of NAD T 775 in the language / languages: English as an attachment in your email.

The manual is 2,09 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NAD T 775

NAD T 775 User Manual - German - 44 pages

NAD T 775 User Manual - Dutch - 44 pages

NAD T 775 User Manual - French - 46 pages

NAD T 775 User Manual - Italian - 44 pages

NAD T 775 User Manual - Swedish - 42 pages

NAD T 775 User Manual - Spanish - 46 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

NAD T 775 Manual

Product: