602914
15
Zoom out
Zoom in
Previous page
1/20
Next page
15
ENGLISH
FRANÇAISDEUTSCHNEDERLANDSESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
M3 REMOTE CONTROL HANDSET (FIGURE 3)
The Remote Control handset handles all the key functions of the M3 and has additional
controls to remotely operate both NAD DVD and CD machines (see CD/DVD Switch below).
It will operate up to a distance of 16ft (5m). Alkaline batteries are recommended for maximum
operating life. Two AA (R6) batteries should be fitted in the battery compartment at the back
of the Remote Control handset. When replacing batteries, check that they have been put in
the right way round, as indicated on the base of the battery compartment.
Please refer to previous sections of the manual for a full description of individual functions.
When a command from the remote control is received, the Status Condition L.E.D. will blink.
1.
ON/OFF: The ON/OFF buttons turn on and to standby the M3. These buttons will only
function when the Status Condition LED is either blue representing the on-state, or amber
representing the standby state.
To turn on the second zone output, first enable the REC/Z2 button (3) as shown by the
red LED beside the REC/Z2 button, then press the ON button. To turn off the second zone
output, enable the REC/Z2 button, then press the OFF button. For further explanation of
the second zone output controls, see REC/Z2 button below.
2. Source Buttons: There are 7 source buttons as well as a REC/Z2 button. For direct input
selection, press the appropriate input button.
3. REC/Z2: Select this button to switch the remote control to a second zone remote control.
The Source Buttons for the second zone will be active as shown by the red LED beside the
REC/Z2 button. There is a 3 second window for selecting a source before this button times
out. Select the source within this duration.
4. SPEAKERS A & B: Select to enable either speaker A, B or both A & B.
5. MODE: Press the MODE button to toggle through the four listening modes. A press
longer than one second will advance the mode selection to the next state as follows;
STEREO, MONO, LEFT, RIGHT, and then return to the STEREO listening mode. Release the
MODE button to stop the sequence.
6. MUTE: Press the MUTE Button to temporarily switch off the sound to the speakers. The
word MUTE will continuously display in the VFD. Press MUTE again or the volume control
to restore sound. The mute function does not affect recordings made using the REC/Z2
output but will affect the signal going to both Preamp outputs.
7. VOL (Volume): Press the VOL or buttons to respectively increase or decrease
the loudness level. Release the button when the desired level is reached. The VFD on the
front panel will indicate the level set. The Master Volume buttons do not affect recordings
made using the REC/Z2 outputs but only affect the signals going to the Preamp outputs.
8. BALANCE: Press the balance button once and then within 5 seconds, press the VOL
or buttons respectively to adjust the either the LEFT or RIGHT balance level. After
about 5 seconds, the balance menu will switch off saving the balance settings in memory.
9. TONE: Press the TONE button to activate or deactivate the tone controls. Release the
TONE button to stop the sequence. To bypass bass, treble, and spectral tilt controls
completely, select TONE DEFEAT (direct bypass of all analogue filters).
Selecting TONE ACTIVE allows one to adjust the bass, treble, and spectral tilt settings of
the M3 by pressing the VOL or buttons respectively. Bass and treble levels are
adjustable between +/- 5dB. The spectral tilt adjustment allows for simultaneous +/-3dB
bass and treble offsets. When adjusting bass and treble levels, the spectral tilt value will
remain 0dB. When adjusting the spectral tilt, the bass and treble values will follow the
spectral tilt adjustment simultaneously.
About the M3 Dual Mono Integrated Amplifier
Operation
M3 10262005.qxd 1/3/2006 2:50 PM Page 15
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NAD M3e at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NAD M3e in the language / languages: English as an attachment in your email.

The manual is 1,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NAD M3e

NAD M3e User Manual - German - 20 pages

NAD M3e User Manual - Dutch - 20 pages

NAD M3e User Manual - French - 20 pages

NAD M3e User Manual - Italian - 20 pages

NAD M3e User Manual - Portuguese - 20 pages

NAD M3e User Manual - Swedish - 20 pages

NAD M3e User Manual - Spanish - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info