745036
6
Zoom out
Zoom in
Previous page
1/32
Next page
ENGLISH
1 o (STANDBY)
Press o (Standby) button for the M17 to be switched ON from
standby mode. The Power indicator will turn from amber to bright/
white color.
Pressing o (Standby) button again switches back M17 to standby
mode. The Power indicator will illuminate to amber color at standby
mode.
The o (Standby) button cannot activate the M17 with the rear
panel POWER switched o.
IMPORTANT NOTES
Refer also to +12V TRIGGER IN (OFF/AUTO) of IDENTIFICATION OF
CONTROLS – REAR PANEL.
For the o (Standby) button to activate, two conditions must be
completed.
a. Plug-in the supplied mains power cord to a mains power source.
Connect corresponding end of the mains power cord to the AC
mains input of M17 and the plug connected to a mains power
source.
b. The rear panel POWER switch must be set to ON position.
2 POWER INDICATOR
This indicator will light up amber when the M17 is at standby mode.
When M17 is powered up from standby mode, this indicator will
turn from amber to bright/white color.
3 REMOTE SENSOR
Point the HTRM 2 remote control at the remote sensor and press
the buttons.
Do not expose the remote sensor of the M17 to a strong light
source such as direct sunlight or illumination. If you do so, you may
not be able to operate the M17 with the remote control.
Distance: About 23ft (7m) from the front of the remote sensor.
Angle: About 30° in each direction of the front of the remote sensor.
4 DISPLAY
Information is displayed as supplied by the applicable source.
There are ve display options – Main, Listen, Dirac, Tone and Zone.
Use your nger to press and select any of these display options to
show their corresponding menu options or settings.
Refer also to the item about FRONT PANEL DISPLAY SETUP under the
USING THE M17 - SETUP MENU segment of the OPERATION section.
The following are sample screenshots of the four display options with
corresponding description of the information shown.
MAIN
Source 1: Current Source.
-20.0 dB: Volume level.
: Go to previous or next Source.
Dolby Atmos: Audio Codec - Detected audio stream format.
HDMI 1/HDMI 1: Audio and video input source.
Object 48k: Audio Source format; sample rate.
1920x1080i60 24 bit RGB 4:4:4: Video mode - Video resolution of
current source with frame rate.
IDENTIFICATION OF CONTROLS
FRONT PANEL
6
© NAD M17
M17
av surround sound preamp processor
4 52 3
1
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NAD M17 V2i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NAD M17 V2i in the language / languages: English as an attachment in your email.

The manual is 4,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NAD M17 V2i

NAD M17 V2i User Manual - German - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info