493489
8
Zoom out
Zoom in
Previous page
1/14
Next page
10 +12V TRIGGER IN
With this input triggered by a 12V DC supply, the M51 can be switched
ON remotely from standby mode by compatible devices such as
ampliers, preampliers, receivers, etc. If the 12V DC supply is cut o,
the M51 will return to standby mode.
Connect this +12V Trigger input to the remote devices
corresponding +12V DC output jack using a mono cable with
3.5mm male plug. The controlling device must be equipped with a
+12V trigger output to use this feature.
WARNING
The front panel Standby button is disabled as long as the male plug of
the mono cable (with or without +12V DC) is connected to M51’s +12V
TRIGGER IN. Unplug the mono cable for the M51 to be normally switched
ON (or back to standby mode) using the front panel STANDBY button.
11 IR IN
This input is connected to the output of an IR (infrared) repeater
(Xantech or similar) or the IR output of another component to allow
control of the M51 from a remote location.
12 POWER
Supply the AC mains power to the M51.
When the POWER switch is set to ON position, the M51 goes to
standby mode as shown by the amber status condition of the
Standby LED. Press the front panel Standby button or remote
control’s [ON] button to switch ON the M51 from standby mode.
If you intend not to use the M51 for long periods of time (such as
when on vacation), switch o the POWER switch.
With POWER switched o, neither the front panel Standby button
nor remote control’s [ON] button can activate the M51.
13 AC MAINS INPUT
The M51 comes supplied with two separate detachable mains
power cord. Select applicable mains power cord pertinent to your
region’s requirement.
Before connecting the plug to the mains powers source, connect
rmly rst the other end to M51’s AC Mains input socket.
Always disconnect the mains power plug from the mains power
source rst, before disconnecting the other end from the M51’s AC
Mains input socket.
14 FUSE HOLDER
Only qualied NAD service techicians can have access to this fuse
holder. Opening this fuse holder may cause damage thus voiding
the warranty of your M51.
IDENTIFICATION OF CONTROLS
REAR PANEL
8
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSK A РУССКИЙ
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NAD M 51 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NAD M 51 in the language / languages: English as an attachment in your email.

The manual is 1,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NAD M 51

NAD M 51 Quick start guide - English - 2 pages

NAD M 51 User Manual - German - 14 pages

NAD M 51 User Manual - Dutch - 14 pages

NAD M 51 User Manual - French - 14 pages

NAD M 51 User Manual - Italian - 14 pages

NAD M 51 User Manual - Swedish - 14 pages

NAD M 51 User Manual - Spanish - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info