The CI 940 may be turned ON in three discrete ways for complete system
exibility - from the front panel standby button, the 12V-TRIGGER circuit or
by the input signal-sensing circuit. The ON/OFF power control is managed
by the Automated Turn-On logic or ATO Logic circuit that requires the
CI 940 to be switched back to standby mode in the same manner it was
activated. In other words, if the CI 940 is switched ON via a +12V-control
signal, it cannot be switched to standby mode via the front panel STANDBY
button, it must wait for removal of the +12V-control signal. In practice, you
probably would use only one of the methods once your CI 940 is installed.
IDENTIFICATION OF CONTROLS
REAR PANEL
CONDITION
STANDBY BUTTON
+12V TRIGGER IN
(using 3.5mm mini-jack plug)
INPUT SENSECI 940 STATUS
Press to enter
Standby mode
Press to turn
ON
+12V0V
Input sense
>20 mV
Input sense
<20 mV
Operating
mode
Standby mode
POWER switch : ON
+12V TRIGGER IN/
INPUT SENSE: OFF
✓✓
✓✓
✓✓
✓✓
✓
✓✓
✓✓
POWER switch : ON
+12V TRIGGER IN/
INPUT SENSE: AUTO
✓✓
✓✓
✓✓
✓✓
✓
✓✓
✓✓
NOTE
If the +12V TRIGGER IN/INPUT SENSE switch is set to OFF, the presence or absence of +12V trigger input or any input signal at the ZONE 1 INPUT or ZONE 2
INPUT terminals will not have any eect on the CI 940, eectively defeating both features.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for NAD CI 940 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of NAD CI 940 in the language / languages: English as an attachment in your email.
The manual is 1,05 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
