798957
5
Zoom out
Zoom in
Previous page
1/32
Next page
5
ANY ENCLOSURE IN WHICH THE APPLIANCE IS USED MUST
COMPLY WITH ONE OF THE FOLLWING:
An enclosure with walls on all sides, but at least one permanent
opening at ground level and no overhead cover. Within a partial
enclosure that includes an overhead cover and no more than
two walls. Within a partial enclosure that includes an overhead
cover and more than two walls, the following shall apply-
at least 25% of the total wall area is completely open; and
at least 30 %of the remaining wall area is open and unrestrict-
ed.
In the case of balconies, at least 20%of the total of the side,
back and front wall areas shall be and remain open and unre-
stricted.
HOSE AND REGULATOR
These items are not included with the pizza oven. Only use
hose and regulators approved for LP gas at the above pres-
sures. The estimated life expectancy of the regulator is 10 years.
Change the regulator within 10 years of the date of manufac-
ture.
Using the wrong hose or regulator is unsafe; always check that
you have the correct items before operating the pizza oven.
The hose used must conform to the relevant standard for the
country of use. The length of the hose must be 1.2 meters
(maximum) and the inner diameter 10 mm. A worn or dam-
aged hose must be replaced. Ensure that the hose is not bent,
clogged, or in contact with any part of the pizza oven other
than at its connection.
LP GAS CYLINDER
The LP gas cylinder should not be dropped or handled roughly!
If the pizza oven is not in use, the cylinder must be disconnect-
ed from the appliance. Place the protective cap on the cylinder
after disconnecting the cylinder from the appliance.
The LP cylinder must be stored outdoors in an upright position
and out of the reach of children. The cylinder must never be
stored in an environment where temperatures can reach over
50°C. Do not store the cylinder near ames, ignition ames, or
other sources of ignition.
DO NOT SMOKE NEAR THE LP GAS CYLINDER.
This pizza oven is designed for use outdoors, away from any
ammable materials. It is important that there are no overhead
obstructions and that there is a minimum distance of 1 m
from the side or rear of the appliance. It is important that the
ventilation openings of the pizza oven are not obstructed. The
pizza oven must be used on a level, stable surface. The appli-
ance should be protected from direct airow and positioned or
protected against direct penetration by any trickling water (e.g.
rain).
No modications should be made to any part of this pizza oven,
and repairs and maintenance should only be carried out by a
registered gas service company.
CONNECTING THE LP GAS CYLINDER
Before connection, ensure that there is no debris or dirt caught
in the head of the LP gas cylinder, regulator, burner, and burner
ports. Spiders and insects can nest within and clog the burner
and its inlet. A clogged burner can lead to a re beneath the
pizza oven.
Clean burner holes with a heavy-duty pipe cleaner.
Fit the hose to the appliance using a spanner to tighten it
onto the connection thread. If the hose is replaced, it must be
secured to the pizza oven and regulator connections with hose
clips. Disconnect the regulator from the cylinder according to
the directions when the pizza oven is not in use.
The pizza oven must be operated in a well-ventilated area. Do
not obstruct the ow of combustion air to the burner when the
appliance is in use. ONLY USE THIS APPLIANCE OUTDOORS.
BEFORE USE, CHECK FOR LEAKS IN THE HOSE AND/OR CONNEC-
TION THREADS.
Never check for leaks with a naked ame; always use a soapy
water solution.
SETTING UP THE PIZZA OVEN
Before the rst time using the oven, inspect it thoroughly for
leaks as instructed. Light up the oven and keep the burner
at Max ( ) for about 20 minutes. This will remove the storage
grease from the oven. Let the oven cool down for about 15 min-
utes. Clean the pizza stone. The pizza oven is now ready for use.
CHECKING FOR LEAKS
Make 2–3 uid ounces (6–9 dl) of leak detecting solution by
mixing one part dishwashing liquid with 3 parts water.
Ensure that the control valve is “OFF”.
Connect the regulator to the LP gas cylinder and ON/OFF valve
to the burner. Ensure that the connections are secure, and then
turn the gas ON.
Brush the soapy solution onto the hose and all joints. If bubbles
appear, you have a leak, which must be repaired before use.
Retest after xing the fault.
Turn the gas OFF at the LP gas cylinder after testing.
If leakage is detected and cannot be repaired, consult your gas
dealer to x the leak.
Outdoor area example 1
Outdoor area example 5
Outdoor area example 4
Outdoor area example 3
Outdoor area example 2
both ends
open
open side at
least 25 % of
total wall area
30 % or more
in total of the
remaining wall
area is open and
unrestricted
open side at
least 25 % of
total wall area
30 % or more
in total of the
remaining wall
area is open and
unrestricted
EN
610626_pizzauuni_Vomero_16_ko_EN-FI-SV-ET-LV-LT-RU.indd 5610626_pizzauuni_Vomero_16_ko_EN-FI-SV-ET-LV-LT-RU.indd 5 16.12.2021 7.47.4716.12.2021 7.47.47
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mustang Vomero 16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mustang Vomero 16 in the language / languages: English, Swedish, Finnish as an attachment in your email.

The manual is 1.62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info