726075
53
Zoom out
Zoom in
Previous page
1/236
Next page
6
Fasten the rope of installation cover on the bolt of the
installation cover. (Refer to Fig.1-14)
Press the installation cover into the panel slightly. (Refer to
Fig.1-14)
Relocate the installation cover.
panel sponge
body
Ceiling
panel
panel foam1
air out
Fan
panel foam 2
4
-
m m 6
outlet foam
Fig.1-12
Fig.1-11
Adjust the four panel hook screws to keep the panel
horizontal,
and screw them up to the ceiling evenly. ( Refer to
Fig.1-10.3)
Regulate the panel in the direction of the arrow in Fig.1-10.4
slightly to fit the panel's center to the center of the ceiling's
opening. Guarantee that hooks of four corners are fixed well.
Keep fastening the screws under the panel hooks, until the
thickness of the sponge between the body and the panel's
outlet has been reduced to about 4~6mm. The edge of the
panel should contact with the ceiling well. (Refer to Fig.1-11)
4
5
Malfunction described in Fig.1-12 can be caused by
inappropriate tightness the screw.
If the gap between the panel and ceiling still exists after
fastening the screws, the height of the indoor unit should
be modified again. ( Refer to Fig.1-13)
You can modify the height of the indoor unit through the
openings on the panel's four c orners, if the lift of the
indoor unit and the drainpipe is not influenced (Refer to
Fig.1-13).
Hang the air-in grill to the panel, then connect the lead
terminator of the swing motor and that of the control box
with corresponding terminators on the body respectively.
Relocate the air-in grill in the procedure of reversed order.
Do
not
coil
the
wiring of the swing motor into the seal
sponge.
CAUTION


Fig.1-10
Tubing joint
Outlet joint
Hook panel
Water-receiver
Swing Motor
Hook-bolt
Cross-screwdriver
Install the panel
Align the swing motor on the panel to the tubing joints of the
body properly. ( Refer to Fig.1-10)
Fix hooks of the panel at swing motor and its opposite sides
to the hooks of corresponding water receiver. ( Refer to
Fig.5-10.1) Then hang the other two panel hooks onto
corresponding hangers of the body. ( Refer to Fig.1-10.2)
3
Fig.1-9 Fig.1-8
Remove the air-in grill.
Slide two grill switches toward the middle at the same time,
and then pull them up. (Refer to Fig.1-7)
Draw the grill up to an angle of about 45, and remove it.
(Refer to Fig.1-8)
Remove the installation covers at the four corners
Wrench off the bolts, loose the rope of the installation covers,
and remove them. (Refer to Fig.1-9)
1
2
Fig.1-7
Models 24 to 60:
53
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MundoClima MUCSR-H9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MundoClima MUCSR-H9 in the language / languages: English, German, French, Portuguese, Spanish as an attachment in your email.

The manual is 15,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info