561614

Multiplex Razor Manual

15
Zoom out
Zoom in
Previous page
1/56
Next page
15
Setting the Centre of Gravity
Like any other aircraft, the DogFighter must be balanced at a particular point in order to achieve stable flying
characteristics. Assemble your model ready to fly, and install the flight battery.
The Centre of Gravity (CG) should be at a position 42 mm aft of the wing root leading edge, i.e. at the
fuselage sides. Fig. 6
Mark this point on both sides of the fuselage. You will find it easier to balance this model inverted: support it
at this position on two fingertips, and it should balance level. If not, you can move the flight battery forward
or aft to correct the balance point. Once the exact position is found, mark the location of the flight pack
inside the model to ensure that it is always replaced in the same position.
Flying the RAZZOR
This model is suitable for advanced pilots only!
For the first flight we recommend the following control surface travels:
Ailerons (down / up): - 4 / + 6 mm (Expo: 40%)
Elevator (down / up): - 6 / + 6 mm (Expo: 40%)
Rudder: 25 mm
1. Launching
We recommend hand-launching this model: apply full throttle, and launch the aeroplane directly into wind with
the wings level and the nose pointing up at about 20 – 30°.
2. Flying
For its size and layout the Razzor has extremely good-natured flying characteristics, and it is capable of
smooth, accurate aerobatics at moderate airspeed and faster. Always fly in good, clear conditions, as the
model’s small size can make orientation difficult.
3. Landing
To avoid premature damage to the undercarriage and the whole airframe we recommend that you carry out the
landing approach with the motor running at low speed, then “flare” at the last moment and allow it to “fall” into
tall grass. If your flying field is mown grass, we recommend that you remove the undercarriage and land the
model on its belly.
The aeroplane will only land cleanly on its wheels on an asphalt surface, or on extremely closely mown grass
where the ground is hard and level.
Parts List, RR Razzor
Part No.Pcs. Description Material Dimensions
1 1 Building instructions, RR / RR+
2 1 Complaint form, models
3 1 Fuselage with 2 servos, controller, motor Moulded Elapor foam Ready made
4 1 Tailplane Moulded Elapor foam Ready made
5 1 Wing with 2 servos Moulded Elapor foam Ready made
6 1 Undercarriage Moulded Elapor foam Ready made
7 1 Propeller driver Metal Ready made
8 2 Propeller Plastic Ready made
9 1 Flight battery LiBATT FX-3/1-800 (M6) Ready made
10 2 Wing retainer screw Metal M3
11 2 Wing retainer nut Metal M3
12 1 Fuselage fairing, undercarriage Plastic Ready made
13 1 Aileron Y-lead Plastic Ready made
14 1 Allen key Metal 1.5 mm A/F
15 2 Velcro tape (hook) Plastic Ready made
16 2 Velcro tape (loop) Plastic Ready made
Additional item included with RR+ version:
17 1 Receiver RX-5 M-LINK ID 5, 2.4 GHz Ready made
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Multiplex Razor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Multiplex Razor in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 1,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info