30258

Multiplex RANGER_III Manual

7
Zoom out
Zoom in
Previous page
1/16
Next page
6
Transmitter, Receiver and Servo Settings
Now we come to the critical part as proper installation of these components are essential.
a. Checking Operation of the Servo
After installation of the servo and receiver into your model is complete, turn the power "ON" the transmitter (fully
extend the antenna) now turn on the receiver.
Check to see if all servos are working properly. If not, check the connections and/or make sure the main battery
pack is charged.
Check to see that the servos are moving in the correct direction. If not, change the servo direction with the
reversing switches located on the bottom of the radio. The 3rd channel of the Ranger 3 FM Sky is not reversible.
If everything checks out then turn the receiver "OFF" first, then the transmitter.
The Ranger 3 FM Sky offers an internal electronic mix for channels 1 and 2 to deliver an Elevon or V-tail mix for
those aircraft requiring those specific functions. (Not used in your EasyStar)
Always remembers to never have the receiver "ON" without the transmitter being "0N".
This means when turning your model "ON" always turn the transmitter "ON" first and "OFF" last.
(Note: Please makes sure to fold the transmitter antenna after use so as not to get damaged or poke someone in
the eyes.)
Warning!!! : Do not shorten the length of the receiver antenna by cutting off any excess wire.
This will severely affect the operating range and could result in injury to yourself and others.
b. Elevator and Aileron Servo Trim Settings
- Trim Setting before Flight
The servo trim enables minor adjustment of the servo neutral position so that the plane will fly straight when the
stick is in the center position. Before adjusting the servo trim, please make sure that when both the stick and the
servo trim is in it's center position (1) the servo arm is perpendicular to the push rods, and (2) the elevator and
aileron of the plane is flush with the tail wing.
- Trim Setting during Flight
You may perform some minor trim adjustment during flight if the plane nose up or down (Elevator Trim) or sideways
(Aileron Trim) when the stick is in the center position.However please keep in mind that trim adjustment is only for
minor adjustment and major adjustment should still be done through push rod (linkage) adjustment at the model.
(Note: There is no trim adjustment on the 3rd channel of the Ranger 3 FM Sky)
c. Adjustable Traveling Volume
You may use this volume to adjust servo traveling according to the characteristics of your model. The servo travel
can be adjusted from 50% to 100% of the total travel range by turning each ATV knob on the transmitter. Turning
clockwise will increase servo travel and counter clockwise will decrease servo travel.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Multiplex RANGER_III at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Multiplex RANGER_III in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info