Manual Multiplex RANGER_III (page 6 of 16) (English, German, French, Italian, Spanish)

30258

Zoom out

Zoom in

1/16

1. Transmitter

a. Loading Batteries

You may use either Alkaline "AA" size batteries or 3rd

party Nicad batteries.

· Push the bottom battery cover in the direction of the

arrow then lift up the cover

· Load 8 AA batteries (Be sure the polarity is correct)

· Reinstall battery case with installed AA batteries.

· Nicad should be charged before use

c. Recharging Nicad Batteries

The Ranger 3 FM Sky is equipped with an external

charging jack so there is no need to remove the Nicad

batteries from the transmitter. The Hitec CG-22A is made

to charge these type of batteries overnight or for

approximately 12 - 15 hours. Please refer to the following

diagram; check to see that the charge lights are lit after

the connection is complete. It is advisable to cycle your

Nicad batteries at least once every 5 or 6 charges. This

can be done by simply turning your transmitter on with

the antenna connected and extended to let it run

completely dead.(Warning!!! Always extend your

antenna as not to overload the circuitry when radio is

on.), then follow the charging method and repeat this 3

times, this will remove the memory that the battery has

stored up if you just simply charge a half dead pack.

d. Changing Crystals

Changing crystal to avoid conflicts with other aircraft is

possible where permitted. (You must check your local

rules before doing so. If you are allowed to change

crystals, both the transmitter and receiver crystals must

be changed together. You must change within the same

band. Use only Hitec crystals when changing

frequencies.

2. Installation of Receiver and Servos

After connecting the receiver and servos as below illustration, turn on the power

to the transmitter first then turn the receiver on. (Always turn the transmitter ON

first and OFF last.) This will prevent the receiver from picking up stray signals

and going out of control. Now move the controls lo see if the servos are moving

properly. lf not, check your wiring or crystals if the servos do not move at all.

b. Reading the LED Battery Indicators

With new alkaline or freshly charged Nicad, the Green light should be lit. With use, the Green light

will turn to Amber. If the Red begins to flash, operation should be stopped and the batteries should

be recharged or replaced immediately.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Multiplex RANGER_III in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,58 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Multiplex RANGER_III Manual

Product: