467082
40
Zoom out
Zoom in
Previous page
1/48
Next page
40
A. Move the collective pitch stick to the minimum position:
Set the nominal rotational speed by adjusting the centre point of servo 5
(throttle).
B. Set the collective pitch stick to the hover setting (centre):
The model should now hover at an unchanged rotational speed. Adjust the
throttle servo until this is the case. If the model hovers above or below the cen-
tre point of the collective pitch stick, the setting of servo 4 (collective pitch)
should be adjusted until you can return the stick to centre.
C. Set the collective pitch stick to maximum collective pitch:
The model should now climb at an unchanged rotational speed, with the car-
burettor fully open, and the motor producing maximum power. If the rotational
speed falls off, the maximum collective pitch value is too high, and you need to
reduce the value for servo 4 (collective pitch).
Static tail rotor compensation
Static tail rotor compensation also needs to be fine-tuned, but this cannot be done
until the throttle and collective pitch curves are correctly set up, and system rota-
tional speed stays constant over the full range of collective pitch. Set the helicopter
in a climb and then allow it to descend again. The model should not yaw (swing
away from its heading) at any time (see 8.6.3).
9. Auxiliary functions
9.1. Stopwatch / MOTOR OFF switch
The COCKPIT
MM
features a stopwatch with variable alarm function and a MOTOR OFF
function. Both functions are controlled by one single 3-position switch.
Centre setting: stopwatch stopped, motor running
End-point 1: stopwatch running, motor running
End-point 2: motor cuts (EMERGENCY OFF), stopwatch stopped
Suitable switches are:
# 7 5740: 3- position, latching in all three positions (On/Off/On)
or # 7 5707: 3- position, latching at one end-point,
momentary at the other (On/Off/Momentary)
!!
The switch must be connected to socket S1 in the transmitter (see 4.1.6.)!
Stopwatch
The stopwatch is accurate to 1/10 second and can be read off in the first line of
operating screens INFO 2 and INFO 3. The stopwatch can be reset in operating
screen INFO 2 or INFO 3 by pressing the 3D digi-adjustor.
If you set an alarm time, the stopwatch counts upwards to this time. 10 seconds
before reaching the alarm the piezo sounder starts beeping once every second.
After reaching the set alarm time the stopwatch carries on running. A trill an-
nounces the set alarm.
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Multiplex Cockpit MM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Multiplex Cockpit MM in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Multiplex Cockpit MM

Multiplex Cockpit MM User Manual - German - 48 pages

Multiplex Cockpit MM User Manual - French - 48 pages

Multiplex Cockpit MM User Manual - Italian - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info