629099
46
Zoom out
Zoom in
Previous page
1/52
Next page
46
Start the engine and allow it to run for a short
period. Stop the engine.
Recheck the coolant level in the overflow
reservoir and refill as needed. Reinstall the
reservoir cap.
INSPECTION OF COOLING SYSTEM HOSES
Check the cooling system hoses and fan belt for
any cracks or deterioration after every 100 hours of
operation. Check for loose hose connections.
Replace any damaged hoses and tighten any loose
connections. Replace a worn or damaged fan belt.
CHANGING THE ENGINE COOLANT
The engine coolant should be drained and replaced
with new coolant solution yearly.
The dry capacity of the cooling system is
approximately 5.2 Liter. Dilute the antifreeze with
water at a 1:1 ratio to mix the coolant solution
(50 % antifreeze : 50 % water).
Change the engine coolant as follows:
Drain the coolant when the engine is cold.
Place the tractor on a level surface and raise the
tractor hood.
Slide the overflow reservoir upward and off the res-
ervoir bracket to access the radiator drain plug.
Locate the radiator drain plug in the lower
right
rear corner of the radiator. See Figure 56.
Figure 56
Place a suitable container beneath the drain
plug and remove the cap from the overflow
reservoir.
Turn the drain plug counterclockwise to re-
move. Allow as much of the old coolant as pos-
sible to drain from the system.
Coolant is a toxic substance. Dispose of in
an environmentally safe manner. Contact
your area EPA office for proper disposal
methods and recycling center locations.
Reinstall the drain plug and turn clockwise until
fully tightened.
Turn the radiator cap counterclockwise to the
first stop, then push downward on the cap and
turn counterclockwise to remove. Refer to
Figure 50.
In stages, SLOWLY pour the coolant solution
into the filler neck, allowing as much air as
possible to escape through the neck. Fill to the
overflow flange of the filler neck.
Wait a few minutes to allow air to escape
through the filler neck and refill as needed, then
reinstall the radiator cap.
Fill the overflow reservoir to the "FULL" mark.
Start the engine and allow it to run for a short
period. Stop the engine.
Recheck the coolant level in the overflow
reservoir and refill as needed. Reinstall the
reservoir cap.
CHANGING THE AIR CLEANER
Check the air cleaner daily or before starting the
engine. Check for loose or damaged components
and check the condition of the filter element.
Remove any buildup of dirt and debris in the air
cleaner housing.
Replace the paper air cleaner element after every
300 hours of operation. More often if operating the
tractor under extremely dusty conditions.
Check and replace the air cleaner element as follows:
Unlock the clamps to remove the air cleaner
housing cover. See Figure 57.
Figure 57
RESERVOIR
BRACKET
RADIATOR
DRAIN PLUG
COVER
COVER
CLAMP
Pull Outward
to Unlock
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MTD CubCadet serie 7000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MTD CubCadet serie 7000 in the language / languages: English as an attachment in your email.

The manual is 2,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MTD CubCadet serie 7000

MTD CubCadet serie 7000 User Manual - German - 55 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info