507839
20
Zoom out
Zoom in
Previous page
1/25
Next page
User manual English
17
Access to the engine
compartment
t~êåáåÖ
qÜÉ=ÉåÖáåÉ=~åÇ=íÜÉ=ëáÇÉ=ÅçîÉêáåÖ=
êÉã~áåçíçê=~áãÉ=~ÑíÉêÜÉåÖáåÉ=
Ü~ë=ÄÉÉå=ëïáíÅÜÉÇ=çÑÑK=tçêâáåÖ=çå=
Üçí=é~êíë=Å~å=äÉ~Ç=íç=ëÉîÉêÉ=ÄìêåëK=
_ÉÑçêÉçìí~êí=ïçêâáåÖåÜáë=~êÉ~I=
~ääçï=~ää=é~êíë=íç=Åççä=ÑáêëíK
Park the tractor on an even, solid
surface.
Lock the parking brake.
Conduct all work with the engine
switched off.
Opening the bonnet
In order to lift the engine bonnet,
look for the ratchet lever in the
border slot below the cooler
cover.
Push the ratchet lever upwards
and keep hold of it, at the same
time tip the bonnet upwards
where the slot of the handle is.
Open the engine bonnet
completely such that the bonnet
holding cylinder holds the bonnet
in the open position.
Removing the side covering
Fold the tonges of the two snap
buckles upwards and turn them
such that they fit through the slots
in the side covering.
Tip the upper part of the side
covering so far until the two
tounges at the lower border of the
covering can be pulled out of the
slots of the covering holders.
Remove the covering.
Re-attach the side coverings
Bring the two closure tounges into
the slots of the covering holders.
Tip the upper part of the covering
towards the tractor and over the
snap buckle tounges.
In order to be able to fully lower the
covering, pull the snap buckle
tounges out a little and turn a
quarter of the way (so that they
stand vertical to the slot). Tip the
holder tounges downwards.
Engine
Observe the servicing notes
described in the engine manual.
Check engine oil level
The oil level should be checked in the
crank housing before each use.
During "running the engine in”, the
engine oil level should be carefully
checked more frequently. The oil level
should be checked every hour during
the first 5 operating hours.
Only check the oil level when the
engine has come to a stand and the
tractor is on a level surface. Keep the
area surrounding the oil dipstick clean
so that no dirt can get into the crank
housing.
Let the engine cool down if the tractor
has been recently driven so that the
oil can flow back into the oil trough.
To check the oil level, take the
dipstick out and wipe it. Place the
dipstick all the way into the tube,
wait a while, then remove in order
to make a accurate reading.
Always keep the oil level between
the MAX (Maximum) und MIN
(Minimum) marks on the dipstick.
Replace the dipstick inserting it
firmly into the measuring tube.
Top up the engine oil
t~êåáåÖ
kÉîÉê=çîÉêÑáää=íÜÉ=Åê~åâ=ÜçìëáåÖK=qÜÉ=
ÉåÖáåÉ=Å~å=çîÉêÜÉ~í=~åÇLçê=Ç~ã~ÖÉ=
Å~å=ÅçãÉ=~Äçìí=áÑ=íÜÉêÉ=áë=íçç=äáííäÉ=çê=
íçç=ãìÅÜ=çáä=áå=íÜÉ=Åê~åâ=ÜçìëáåÖK=
áë=ÄÉííÉê=íç=Ñáää=íç=íÜÉ=“j^uÒ=
Ej~ñáãìãF=çå=íÜÉ=ÇáéëíáÅâ=íÜ~å=íç=
éçìê=áå=~=ëÉí=~ãçìåíK=cáêëí=ÅÜÉÅâ=íÜÉ=
çáä=äÉîÉä=çå=íÜÉ=ÇáéëíáÅâ=ÄÉÑçêÉ=
íçééáåÖ=ìé=ïáíÜ=çáäK=
You can read more about the
correct engine oil type for topping up
and the various environmental
conditions under which the engine
can be operated in the lubricant
table and/or the engine handbook.
Park the tractor on a level surface
and engage the parking brake.
Stop the tractor engine and
remove the ignition key.
Keep the area surrounding the oil
dipstick clean so that no dirt can
get into the crank housing.
To remove the oil-fill supports,
turn the oil-fill lid anti-clockwise.
Slowly pour oil into the crank
housing until it reaches the MAX
mark (Maximum) on the dipstick.
!
MIN
MAX
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MTD CubCadet serie 6000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MTD CubCadet serie 6000 in the language / languages: English as an attachment in your email.

The manual is 2,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MTD CubCadet serie 6000

MTD CubCadet serie 6000 User Manual - German - 26 pages

MTD CubCadet serie 6000 User Manual - Dutch - 26 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info