Manual Mountfield 4155H (page 9 of 86) (English, German, Dutch, French)

765491

Zoom out

Zoom in

1/86

ENGLISH EN

c. Stopping the engine and removing the key.

• Only use accessories that are approved by the

machine’s Manufacturer.

• The machine may not be used without

accessories/tools being installed in the

machine’s tool mounts. Driving without

accessories can have a negative effect on the

stability of the machine.

• Take care when using grass collectors and other

accessories. These can alter the machine’s

stability. Particularly on slopes.

• Disengage the drive to the accessories, shut off

the engine and disconnect the spark plug cable

or remove the starter key:

a. To remove sticks and rubbish or when the

discharge has become clogged.

b. To check, clean or service the machine.

c. To check whether damage has occurred and

to carry out any repairs before starting and

using the machine again after a collision with a

foreign object.

d. To check the machine if it begins to vibrate

excessively. (Check immediately).

• Disengage the drive to accessories during

transport or when the machine is not in use.

• Shut off the engine and disconnect the drive to

the accessories:

a. Before filling with petrol.

b. Before removing the grass collector.

c. Before adjusting the height setting, assuming

this cannot be done from the driver’s position.

• Reduce the acceleration when the engine is to

be stopped, and if the engine is equipped with a

fuel shut-off valve, this should be switched off

when the work is finished.

• Take care with multiple blade decks as one

rotating blade can cause other blades to rotate.

• The machine, equipped with original

accessories, must not be driven in any direction

on slopes with a gradient greater than 10º.

• The cutting deck’s original blade(s) may not be

replaced with non-original devices intended for

e.g. moss scarification. If such devices are used,

the guarantee will cease to be valid. There is

also a risk of serious injury or damage to people

or property.

• Take care when unloading and loading the

machine onto a trailer or lorry.

2.4 MAINTENANCE AND STORAGE

• Tighten all nuts and screws so that the machine

is in safe working condition.

• At regular intervals check that the cutting

deck’s blade screw(s) are properly tightened.

• Regularly check the operation of the brakes. It

is important to maintain and repair the brakes if

necessary.

• Never store the machine with petrol in the tank

in buildings where the fumes can come into

contact with open flames or sparks.

• Allow the engine to cool before placing the

machine in a store.

• To reduce the risk of fire, keep the engine,

silencer, battery and petrol tank free from grass,

leaves and surplus oil.

• Check frequently whether there is any wear or

damage to the grass collector.

• For the sake of safety, replace worn or damaged

parts.

• Always use genuine spare parts. Non-genuine

spare parts can entail a risk of injury, even if

they fit the machine.

• Replace damaged warning and instruction

stickers.

• If there is no mechanical lock for the transport

position, the cutting deck must be lowered

when parked, stored or when the machine is left

unsupervised.

• If the petrol tank is to be emptied, this must take

place outdoors.

• Store the machine so that children cannot get to it.

2.5 STORAGE

Empty the petrol tank. Start the engine and let it

run until it stops.

Replace the oil while the engine is still warm.

Unscrew the spark plug and pour a tablespoonful

of oil into the cylinder. Rotate the engine a few

turns to that the oil is distributed in the cylinder.

Install the spark plug.

Clean the entire machine. It is particularly

important to clean under the cutting deck. Touch

up paint damage to prevent rust.

Store the machine indoors in a dry place.

Machines with an electric starter:

Remove the battery. Store it well charged in a cool

place (between 0°C and +15°C).

At the correct storage temperature, the battery

should be maintenance-charged every four

months.

The battery acid is extremely corrosive

and can cause injuries and damage to

skin and clothing. Always use rubber

gloves and glasses (goggles) to protect

your eyes. Avoid inhaling any acid

vapour.

Do not incline the battery too much so

that the battery acid can run out onto

hands or clothing. If this should

happen, rinse with plenty of water.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Mountfield 4155H in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,41 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Mountfield 4155H Manual

Product: