474370

Mottez A014PCAD Manual

12
Zoom out
Zoom in
Previous page
1/35
Next page
ENGLISH
7a – Fitting the lower straps to the side beams:
- Pass the two hooks B through the loops formed by the lower straps A.
- Attach the lower straps under the vehicle to the metal side beams or metal hooks.
- Ensure that the straps are not too close to the silencer, as there is a risk of damage.
Fixing to the bumper is not permitted
7b – Fitting the lower straps on to the tailgate:
- Attach to two lower straps to the lower metal rim of the tailgate.
NEVER SUPPORT ON A PLASTIC COMPONENT.
8 – Tightening the straps:
- Tighten the straps to obtain perfect positioning on the car.
- Check that everything is properly tightened by pushing the cycle carrier hard in all directions; it
should not move on the vehicle. If this is not the case, tighten all the straps again.
9 – Fitting the complete grip straps:
- Attach the complete grip straps (red), C and D, to the cycle carrier’s framework.
10 – Strapping on the bicycles:
- Position the first bicycle with the chain facing towards the vehicle.
- Fit the bicycles alternately facing in the opposite direction, so that the handlebars do not foul on each
other.
- The bicycles must be distributed correctly on the cycle carrier, snugly and as close to the vehicle as
possible. The centre of gravity of the assembly must be as low as possible, without the bicycles being
able to touch the ground when passing over an obstacle (speed bump, etc.).
- Loads sticking out beyond the cycle carrier must comply with current regulations and must be
appropriately fixed. It is the user’s responsibility to comply with the standards applying in each country
where the carrier is used.
E.g. In France the load must not exceed a total width of 2.5 m.
- Ensure that cycle tyres are not too close to the vehicle’s tail pipe; hot exhaust gases could damage
them.
11 – Strapping on the bicycles:
- It is essential to fix the bicycle frames using straps E, securing them firmly to the cycle carrier’s
frame.
ATTENTION: THESE STRAPS PROVIDE YOUR SAFETY.
12 – Complete grip of the bicycles:
- Pass the complete grip straps, C and D (red), through the wheels: they prevent the bicycles falling
off.
- They ensure that the bicycles are held on the frame.
ATTENTION: THESE STRAPS PROVIDE YOUR SAFETY.
13 – Checking the tightness of the straps:
- The lower cycle carrier straps must be re-tightened.
- Check the other straps to ensure that there is no movement.
- Check that everything is properly tight by attempting to move the bicycles; they must not move on the
cycle carrier. If this is not the case, tighten all the straps again.
- Do not allow the straps to flap in the wind; use the elastic straps E provided.
14 - Use:
- Comply with current regulations and the Highway Code.
-We draw your attention to the fact that incorrect installation or use can result in danger for you and
others, for which you may be held liable.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mottez A014PCAD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mottez A014PCAD in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 5,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info