Getting Started 9
ENGLISH
2.3 Owner Unit Power Supply
IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is
recommended. This will allow the unit to operate on battery in the event
of a power failure.
1. Connect the small plug of the power adapter to the
owner
unit and
the other end to the electrical outlet. Only use the enclosed power
a
dapter (6V DC/500mA).
2. Press and hold the
P POWER ON/OFF button for 1 second to
turn ON the
owner
unit.
3. Once the pet and
owner
units are switched on, the display on the
owner
unit will show the video captured by the pet unit.
4. If there is no connection or you are out of range, the video display
will go off and
will be shown on the LCD display, and the unit will
beep every 5 seconds. Move the
owner
unit closer to the pet unit
until the link is re-established.
5. Press and hold the
P POWER ON/OFF button, until the progress
b
ar finishes scrolling, to turn OFF the
owner
unit.
NOTE
The battery icon turns RED to indicate that the battery is low, and it
gives a beep every 16 seconds. The battery needs to be recharged. The
battery pack takes about 16 hours to charge fully.
When charging
1. During power OFF, when adapter is plugged in, an adapter logo will
display on screen and then a flashing battery logo will display for 45 sec.
The Blue LED at top left corner light up indicates adapter is plugged in.