765190
21
Zoom out
Zoom in
Previous page
1/32
Next page
Wartungsinformation / Maintenance Information
Wartungsanleitung
ACHTUNG: Ziehen Sie immer den Stecker aus der
Steckdose, bevor Sie das Gerät reinigen oder warten.
Regelmäßiges Reinigen verlängert die Lebensdauer
dieses Gerätes. Halten Sie das Gerät sauber, indem
Sie es regelmäßig abstauben und absaugen.Ist die
Laufmatte sehr verschmutzt, benutzen Sie ein feuchte
Tuch, aber keine Reinigungsmittel. Säubern Sie die
Oberflächen des Laufdecks auf beiden Seiten der
Laufmatte sowie die seitlichen Schienen. Halten Sie
Ihre Laufschuhe sauber, um zu verhindern, dass
Schmutz unter die Laufmatte kommt. Stellen Sie
sicher, dass keine Feuchtigkeit ins Cockpit gelangt.
Die Laufmatte Einfetten
Dieses Gerät wird mit einem Silikon Öl vorgeschmiert
bevor es ausgeliefert wird. Silikon Öl verflüchtigt sich
nicht und durchdringt die Laufmatte. Normalerweise
ist selten weiteres Schmieren nötig. Im Lieferumfang
enthalten ist eine Flasche des Silikon Öls, so dass
Sie die Laufmatte einfetten können, wenn die
Laufmatte anfängt am Laufdeck zu reiben. Wir
empfehlen regelmäßige Kontrolle des Decks. Bitte
kontaktieren Sie unseren Kundenservice, wenn Sie
Schäden am Laufdeck finden. Heben Sie die Laufmatte
von beiden Seiten hoch, tragen Sie das Silikon Öl
auf und legen die Laufmatte dann wieder mittig auf.
Erlauben Sie dem Silikon Öl sich gleichmäßig zu
verteilen, bevor Sie Ihr Gerät benutzen.
ACHTUNG:
Verwenden Sie kein anderes Schmiermittel, da
dies das Laufband beschädigt. Verwenden Sie
nicht zu viel Silikon Öl. Überschüssiges Öl kann
mit einem Lappen abgewischt werden.
LUBRICATING THE RUNNING BELT
Dependent upon usage and user weight it will be
necessary periodically to lubricate the underside
of the Running Belt.
To ensure that this is done successfully, take the
5mm Allen Wrench and adjust the Rear Roller
Location Bolts, which are accessible through the
Rear Frame Caps. Rotate each bolt a full 4 turns
ANTI-CLOCKWISE to slacken off the belt.
Lift the sides of the belt and run a small bead of
lubricant onto the Running Board and if possible
spread this with a small brush or cloth to ensure
even coverage on the Running Board.
Re-tighten the Running Belt by adjusting the Rear
Roller Location Bolts CLOCKWISE until the belt is
running centrally on the Running Board.
Please see table below for suggested lubrication
frequency. Please follow the guide below to
ensure efficient operation of your Treadmill.
Light Use of up to 3 hours per week – Lubricate
every 8 months.
Moderate Use of up to 5 hours per week –
Lubricate every 4 months.
Heavy or Extended Use over 5 hours per week –
Lubricate every 3 months.
Your Treadmill Running Deck has been pre-lubricated
at the factory and should need no immediate
attention. Please refer to the enclosed maintenance
advice for the lubrication schedule. A suitable Silicon
lubricant can be purchased either from us directly,
or from most hardware/DIY stores.

21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Motive FIitness - U.N.O. V-Fit Speed Master 1.8M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Motive FIitness - U.N.O. V-Fit Speed Master 1.8M in the language / languages: English, German as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info