Manual Morso 8100 series (page 26 of 36) (English, Danish)

744367

Zoom out

Zoom in

1/36

Sprog

N.B!

Wood is a material that contains a great deal of gas (approximately 75 %). The gases are

released when the wood is lit and heated up. For this reason, it is important that the ga-

ses are ignited quickly after stoking. If the wood just lies smouldering, especially after

re-stoking, a lot of smoke is created, which, in the worst case, may cause an explosive

ignition of the gasses, resulting in damage to the stove.

In order to ignite the gases that are released from the wood, and to keep clear, lasting

ﬂames during the combustion process, it is important to let in the required quantity of

oxygen (air supply) at all times.

The setting of the air supply, the method of ignition and the lighting intervals depend

on the draught in the chimney, the wind and weather, the amount of heat required, the

fuel, etc. This means that it may take some time before you get to know the correct

functioning of the stove under any given circumstances.

Although you can ﬁre your Morsø stove with almost all kinds of wood, you should not

ﬁre with wet wood, or unseasoned wood. Wood ought to be stored under a roof for at

least 1 year, and preferably 2 years, with free access to wind. Wood should be chopped

as soon as possible after felling if it is to dry quickly. The wood can be used once the

moisture content is less than 20%. During the EN test, all stoves are tested with wood

with a moisture content of (16 ± 4)%.

Never use driftwood, as it usually has a high salt content, which damages both the stove

and the chimney. Impregnated and painted wood and chipboard emit poisonous smoke

and fumes, so they should not be used as fuel either.

Please note that liquid fuel may not be used in the stove.

Pieces of wood with a diameter greater than 10 cm should always be chopped.

The pieces of wood should be short enough to be able to lie ﬂat over the layer of embers, with

air at both ends. The maximum length of fuel in the stove is 30 cm. The maximum quantity of

fuel is 2.5 kg/hour (max. 3 pieces of wood each time you re-stoke).

The ﬁrst few times you light the stove, the ﬁre should be moderate, so that the heat-

resistant paint can harden before ﬁring more vigorously. During the hardening phase,

the paint may develop obnoxious smoke and smell the ﬁrst time it is lit, which is very

normal. Make sure that the room is well ventilated during this period.

When heating up or cooling down, the material is exposed to major temperature diffe-

rences that may cause the stove to give off creaking sounds.

2.0 Firing/using the stove

Your stove is constructed with air inlets in two places.

Pre-heated, fast-moving combustion air is added to the ﬁre above the glass window, and is

regulated using the handle above the door. The combustion air is let in when the handle is

pushed to the right, and shut off when the handle is pushed to the left.

Another air inlet provides a constant, pre-heated air supply which cannot be adjusted, and

which comes into the combustion chamber just above the ﬁre. This helps to burn off the last

few gasses emitted by the wood whilst it is being heated up.

The riddling grate is operated using the riddle bar, which is located behind the door.

The stove’s rated heat output is 6 kW. Your new Morsø stove is EN-tested for ﬁring with wood,

and is suitable for intermittent use.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Morso 8100 series in the language / languages: English, Danish as an attachment in your email.

The manual is 0,27 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Morso 8100 series

Morso 8100 series Usermanual and installation guide - German - 20 pages

Morso 8100 series Usermanual and installation guide - Dutch, French - 36 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Morso 8100 series Manual

Product: